|
|
PDF MC10E111 Data sheet ( Hoja de datos )
| Número de pieza | MC10E111 | |
| Descripción | 1:9 DIFFERENTIAL CLOCK DRIVER | |
| Fabricantes | Motorola Semiconductors | |
| Logotipo |  |
|
Hay una vista previa y un enlace de descarga de MC10E111 (archivo pdf) en la parte inferior de esta página. Total 5 Páginas | ||
|
No Preview Available !
MOTOROLA
SEMICONDUCTOR TECHNICAL DATA
1:9 Differential Clock Driver
The MC10E/100E111 is a low skew 1-to-9 differential driver, designed
with clock distribution in mind. It accepts one signal input, which can be
either differential or else single-ended if the VBB output is used. The
signal is fanned out to 9 identical differential outputs. An enable input is
also provided. A HIGH disables the device by forcing all Q outputs LOW
and all Q outputs HIGH.
• Low Skew
• Guarateed Skew Spec
• Differential Design
• VBB Output
• Enable
• Extended 100E VEE Range of –4.2 to –5.46V
• 75kΩ Input Pulldown Resistors
The device is specifically designed, modeled and produced with low
skew as the key goal. Optimal design and layout serve to minimize gate to
gate skew within-device, and empirical modeling is used to determine
process control limits that ensure consistent tpd distributions from lot to
lot. The net result is a dependable, guaranteed low skew device.
To ensure that the tight skew specification is met it is necessary that
both sides of the differential output are terminated into 50Ω, even if only
one side is being used. In most applications, all nine differential pairs will
be used and therefore terminated. In the case where fewer than nine
pairs are used, it is necessary to terminate at least the output pairs on the
same package side (i.e. sharing the same VCCO) as the pair(s) being
used on that side, in order to maintain minimum skew. Failure to do this
will result in small degradations of propagation delay (on the order of
10–20ps) of the output(s) being used which, while not being catastrophic
to most designs, will mean a loss of skew margin.
PIN NAMES
Pin Function
IN, IN
EN
Q0, Q0–Q8, Q8
VBB
Differential Input Pair
Enable
Differential Outputs
VBB Output
Q0 Q0 Q1 VCCO Q1 Q2 Q2
25 24 23 22 21 20 19
VEE 26
18
EN 27
17
IN 28
VCC 1
IN 2
Pinout: 28-Lead PLCC
(Top View)
16
15
14
VBB 3
NC 4
5
Q8
13
12
6 7 8 9 10 11
Q8 Q7 VCCO Q7 Q6 Q6
Q3
Q3
Q4
VCCO
Q4
Q5
Q5
5/95
© Motorola, Inc. 1996
2–1
MC10E111
MC100E111
1:9 DIFFERENTIAL
CLOCK DRIVER
FN SUFFIX
PLASTIC PACKAGE
CASE 776-02
LOGIC SYMBOL
IN
IN
EN
VBB
Q0
Q0
Q1
Q1
Q2
Q2
Q3
Q3
Q4
Q4
Q5
Q5
Q6
Q6
Q7
Q7
Q8
Q8
REV 3
1 page  
MC10E111 MC100E111
Motorola reserves the right to make changes without further notice to any products herein. Motorola makes no warranty, representation or guarantee regarding
the suitability of its products for any particular purpose, nor does Motorola assume any liability arising out of the application or use of any product or circuit, and
specifically disclaims any and all liability, including without limitation consequential or incidental damages. “Typical” parameters which may be provided in Motorola
data sheets and/or specifications can and do vary in different applications and actual performance may vary over time. All operating parameters, including “Typicals”
must be validated for each customer application by customer’s technical experts. Motorola does not convey any license under its patent rights nor the rights of
others. Motorola products are not designed, intended, or authorized for use as components in systems intended for surgical implant into the body, or other
applications intended to support or sustain life, or for any other application in which the failure of the Motorola product could create a situation where personal injury
or death may occur. Should Buyer purchase or use Motorola products for any such unintended or unauthorized application, Buyer shall indemnify and hold Motorola
and its officers, employees, subsidiaries, affiliates, and distributors harmless against all claims, costs, damages, and expenses, and reasonable attorney fees
arising out of, directly or indirectly, any claim of personal injury or death associated with such unintended or unauthorized use, even if such claim alleges that
Motorola was negligent regarding the design or manufacture of the part. Motorola and are registered trademarks of Motorola, Inc. Motorola, Inc. is an Equal
Opportunity/Affirmative Action Employer.
How to reach us:
USA/EUROPE/Locations Not Listed: Motorola Literature Distribution;
P.O. Box 20912; Phoenix, Arizona 85036. 1–800–441–2447 or 602–303–5454
MFAX: [email protected] – TOUCHTONE 602–244–6609
INTERNET: http://Design–NET.com
JAPAN: Nippon Motorola Ltd.; Tatsumi–SPD–JLDC, 6F Seibu–Butsuryu–Center,
3–14–2 Tatsumi Koto–Ku, Tokyo 135, Japan. 03–81–3521–8315
ASIA/PACIFIC: Motorola Semiconductors H.K. Ltd.; 8B Tai Ping Industrial Park,
51 Ting Kok Road, Tai Po, N.T., Hong Kong. 852–26629298
ECLinPS and ECLinPS Lite
DL140 — Rev 4
◊
*MC10E111/D*MC10E111/D
2–5 MOTOROLA
5 Page | ||
| Páginas | Total 5 Páginas | |
| PDF Descargar | [ Datasheet MC10E111.PDF ] | |
Hoja de datos destacado
| Número de pieza | Descripción | Fabricantes |
| MC10E111 | 1:9 DIFFERENTIAL CLOCK DRIVER | Motorola Semiconductors |
| MC10E111 | 1:9 DIFFERENTIAL CLOCK DRIVER |  ON Semiconductor |
| MC10E112 | QUAD DRIVER | Motorola Semiconductors |
| MC10E112 | QUAD DRIVER | ON Semiconductor |
| Número de pieza | Descripción | Fabricantes |
| SLA6805M | High Voltage 3 phase Motor Driver IC. |
 Sanken |
| SDC1742 | 12- and 14-Bit Hybrid Synchro / Resolver-to-Digital Converters. |
 Analog Devices |
|
DataSheet.es es una pagina web que funciona como un repositorio de manuales o hoja de datos de muchos de los productos más populares, |
| DataSheet.es | 2020 | Privacy Policy | Contacto | Buscar |