DataSheet.es    


PDF RTL8812AU-CG Data sheet ( Hoja de datos )

Número de pieza RTL8812AU-CG
Descripción SINGLE-CHIP IEEE 802.11ac 2T2R WLAN CONTROLLER
Fabricantes Realtek Microelectronics 
Logotipo Realtek Microelectronics Logotipo



Hay una vista previa y un enlace de descarga de RTL8812AU-CG (archivo pdf) en la parte inferior de esta página.


Total 18 Páginas

No Preview Available ! RTL8812AU-CG Hoja de datos, Descripción, Manual

RTL8812AU-CG
SINGLE-CHIP IEEE 802.11ac 2T2R WLAN
CONTROLLER WITH USB 2.0/3.0
INTERFACE
DATASHEET
(CONFIDENTIAL: Development Partners Only)
Rev. 0.2
24,May, 2011
Track ID: JATR-2265-11
Realtek Semiconductor Corp.
No. 2, Innovation Road II, Hsinchu Science Park, Hsinchu 300, Taiwan
Tel.: +886-3-578-0211. Fax: +886-3-577-6047
www.realtek.com

1 page




RTL8812AU-CG pdf
RTL8812AU
Datasheet
1. General Description
The Realtek RTL8812AU-CG is a highly integrated single-chip MIMO (Multiple In, Multiple Out) Wireless
LAN (WLAN) USB 2.0/3.0 network interface controller complying with the wireless very high throughput
IEEE 802.11ac Draft 2.0 and 802.11n specifications. The RTL8812AU-CG provides a complete solution for a
high-performance wireless client and also supports WiFi Direct feature that can easily build a WiFi P2P PAN
network.
The RTL8812AU-CG baseband implements Multiple Input, Multiple Output (MIMO) Orthogonal Frequency
Division Multiplexing (OFDM) with two transmit and two receive paths (2T2R). Features include two spatial
stream transmissions, short Guard Interval (GI) of 400ns, spatial spreading, and support for both 20MHz,
40MHz and 80MHz channel bandwidth. Moreover, RTL8812AU provides one spatial stream space-time block
code (STBC) , Transmit Beamforming (TxBF) and Low Density Parity Check (LDPC) to extend the range of
transmission. At the receiver, extended range and good minimum sensitivity is achieved by having receiver
diversity up to 2 antennas. As the recipient, the RTL8812AU also supports explicit sounding packet feedback
that helps senders with beamforming capability. With 2 independent RF blocks, the RTL8812AU can perform
fast roaming without link interruption.
For legacy compatibility, Direct Sequence Spread Spectrum (DSSS), Complementary Code Keying (CCK) and
OFDM baseband processing are included to support all IEEE 802.11b, 802.11g and 802.11a data rates.
Differential phase shift keying modulation schemes, DBPSK and DQPSK with data scrambling capability are
available, and CCK provides support for legacy data rates, with long or short preamble. The high speed
FFT/IFFT paths, combined with BPSK, QPSK, 16QAM, 64QAM and 256QAM modulation of the individual
subcarriers, and rate compatible coding rate of 1/2, 2/3, 3/4, and 5/6, provide up to 866.7Mbps for IEEE
802.11ac MIMO OFDM.
The RTL8812AU-CG builds in an enhanced signal detector, an adaptive frequency domain equalizer, and a
soft-decision Viterbi decoder to alleviate severe multi-path effects and mutual interference in the reception of
multiple streams. For better detection quality, receive diversity with Maximal-Ratio-Combine (MRC) applying
up to two receive paths is implemented. Robust interference detection and suppression are provided to protect
against Bluetooth, cordless phone, and microwave oven interference.
Receive vector diversity for multi-stream application is implemented for efficient utilization of the MIMO
channel. Efficient IQ-imbalance, DC offset, phase noise, frequency offset, and timing offset compensations are
provided for the radio frequency front-end. Selectable digital transmit and receive FIR filters are provided to
meet transmit spectrum mask requirements and to reject adjacent channel interference, respectively.
Single-Chip IEEE 802.11a/b/g/n/ac 2T2R WLAN
Controller with USB3.0 Interface
1
Track ID: JATR-2265-11 Rev. 0.2

5 Page





RTL8812AU-CG arduino
4.1. Package Identification
Green package is indicated by a „G‟ in the location marked „T‟ in Figure 2.
RTL8812AU
Datasheet
5. Pin Descriptions
The following signal type codes are used in the tables:
I: Input
T/S: Tri-State bi-directional input/output pin
O/D: Open Drain
O: Output
S/T/S: Sustained Tri-State
P: Power pin
5.1. USB Express Transceiver Interface
Symbol
HSDP/HSDM
HSON/USOP
HSIN/HSIP
Type
I/O
O
I
Table 1. USB Transceiver Interface
Pin No Description
41, 42 High speed USB Differential Pair
48, 49
Super speed USB tx differential pair
51, 52
Super speed USB rx differential pair.
Single-Chip IEEE 802.11a/b/g/n/ac 2T2R WLAN
Controller with USB3.0 Interface
7
Track ID: JATR-2265-11 Rev. 0.2

11 Page







PáginasTotal 18 Páginas
PDF Descargar[ Datasheet RTL8812AU-CG.PDF ]




Hoja de datos destacado

Número de piezaDescripciónFabricantes
RTL8812AU-CGSINGLE-CHIP IEEE 802.11ac 2T2R WLAN CONTROLLERRealtek Microelectronics
Realtek Microelectronics

Número de piezaDescripciónFabricantes
SLA6805M

High Voltage 3 phase Motor Driver IC.

Sanken
Sanken
SDC1742

12- and 14-Bit Hybrid Synchro / Resolver-to-Digital Converters.

Analog Devices
Analog Devices


DataSheet.es es una pagina web que funciona como un repositorio de manuales o hoja de datos de muchos de los productos más populares,
permitiéndote verlos en linea o descargarlos en PDF.


DataSheet.es    |   2020   |  Privacy Policy  |  Contacto  |  Buscar