DataSheet.es    


PDF SY88309BL Data sheet ( Hoja de datos )

Número de pieza SY88309BL
Descripción 3.2Gbps PECL Limiting Post Amplifier
Fabricantes Micrel Semiconductor 
Logotipo Micrel Semiconductor Logotipo



Hay una vista previa y un enlace de descarga de SY88309BL (archivo pdf) en la parte inferior de esta página.


Total 11 Páginas

No Preview Available ! SY88309BL Hoja de datos, Descripción, Manual

SY88309BL
3.3V, 3.2Gbps PECL Limiting Post Amplifier
with Wide Signal-Detect Range
General Description
The SY88309BL low-power limiting post amplifiers are
designed for use in fiber-optic receivers. These devices
connect to typical transimpedance amplifiers (TIAs). The
linear signal output from TIAs can contain significant
amounts of noise and may vary in amplitude over time.
The SY88309BL quantizes these signals and output
PECL-level waveforms.
The SY88309BL operates from a single +3.3V power
supply, over temperatures ranging from –40oC to +85oC.
With their wide bandwidth and high gain, signals with
data rates up to 3.2Gbps, and as small as 10mVpp, can
be amplified to drive devices with CML or PECL inputs.
It generates a Signal Detect (SD) open-collector TTL
output. The SD function is optimized to detect a larger
and wider input range, as shown in the characteristic
curve on page 6. A programmable signal-detect level set
pin (SDLVL) sets the sensitivity of the input amplitude
detection.
SD asserts high if the input amplitude rises above the
threshold sets by SDLVL and de-asserts low otherwise.
The SD output can be fed back to the EN input to
maintain stability. Typically, 3.5dB LOS/SD hysteresis is
provided to prevent chattering.
Datasheet and support documentation can be found on
Micrel’s web site at: www.micrel.com.
Features
Signal Detect circuit optimized to detect a larger and
wider input range (20mVPP-140mVPP)
Chatter-free Open-Collector TTL Signal-Detect (SD)
Single 3.3V power supply
155Mbps to 3.2Gbps operation
Low-noise PECL data outputs
Programmable SD level set (SDLVL)
Available in a tiny 10-pin EPAD-MSOP and 16-pin
QFN package
Applications
PON
Gigabit Ethernet
1X and 2X Fibre Channel
SONET/SDH:OC-3/12/24/48 – STM 1/4/8/16
High-gain line driver and line receiver
Markets
FTTX
Optical transceivers
Datacom/Telecom
Low-gain TIA interface
Long-reach FOM
Micrel Inc. • 2180 Fortune Drive • San Jose, CA 95131 • USA • tel +1 (408) 944-0800 • fax + 1 (408) 474-1000 • http://www.micrel.com
November 2007
M9999-111507-C
[email protected] or (408) 955-1690

1 page




SY88309BL pdf
Micrel, Inc.
SY88309BL
AC Electrical Characteristics
VCC = 3.0V to 3.6V; RL = 50to VCC-2V; TA = –40°C to +85°C; typical values at VCC = 3.3V, TA = +25°C.
Symbol
tr, tf
Parameter
Output Rise/Fall Time
(20% to 80%)
Condition
Note 4
Min Typ Max Units
150 ps
tJITTER
VID
VOD
TOFF
TON
SDAL
SDDL
HYSL
SDAM
SDDM
HYSM
SDAH
SDDH
HYSH
B-3dB
AV(Diff)
S21
Deterministic
Random
Differential Input Voltage Swing
Differential Output Voltage Swing
SD Assert Time
SD De-assert Time
Low SD Assert Level
Low SD De-assert Level
Low SD/LOS Hysteresis
Medium SD Assert Level
Medium SD De-assert Level
Medium SD/LOS Hysteresis
High SD Assert Level
High SD De-assert Level
High SD/LOS Hysteresis
3dB Bandwidth
Differential Voltage Gain
Single-ended Small-Signal Gain
Note 5
Note 6
Figure 1
VID > 12mVPP, Figure 1
RSDLVL = 15k, Note 8
RSDLVL = 15k, Note 8
RSDLVL = 15k, Note 7
RSDLVL = 5k, Note 8
RSDLVL = 5k, Note 8
RSDLVL = 5k, Note 7
RSDLVL = 100, Note 8
RSDLVL = 100, Note 8
RSDLVL = 100, Note 7
15 psPP
5 psRMS
5 1800 mVPP
1500
2
mVPP
10 µs
2 10 µs
27 mVPP
18 mVPP
3.4 dB
53 80 mVPP
21 36
mVPP
2 3.5 6 dB
137 200 mVPP
70 94
mVPP
2 3.5 6 dB
1.8 GHz
42 dB
30 36
dB
Notes:
4. Amplifier in limiting mode. Input is a 200MHz, 100mVpp square wave.
5. Deterministic jitter measured using 3.2Gbps K28.5 pattern, VID = 10mVPP.
6. Random jitter measured using 3.2Gbps K28.7 pattern, VID = 10mVPP.
7. This specification defines electrical hysteresis as 20log (LOS De-assert/LOS Assert). The ratio between optical hysteresis and electrical
hysteresis is found to vary between 1.5 and 2, depending upon the level of received optical power and ROSA characteristics. Based upon that
ratio, the optical hysteresis corresponding to the electrical hysteresis range 2dB-6dB, shown in the AC characteristics table, will be 1dB-3dB
Optical Hysteresis.
8. See “Typical Operating Characteristics” for a graph showing how to choose a particular RSDLVL for a particular SD assert and its associated de-
assert amplitude.
November 2007
5 M9999-111507-C
[email protected] or (408) 955-1690

5 Page





SY88309BL arduino
Micrel, Inc.
SY88309BL
MICREL, INC. 2180 FORTUNE DRIVE SAN JOSE, CA 95131 USA
TEL +1 (408) 944-0800 FAX +1 (408) 474-1000 WEB http://www.micrel.com
The information furnished by Micrel in this data sheet is believed to be accurate and reliable. However, no responsibility is assumed by Micrel for
its use. Micrel reserves the right to change circuitry and specifications at any time without notification to the customer.
Micrel Products are not designed or authorized for use as components in life support appliances, devices or systems where malfunction of a
product can reasonably be expected to result in personal injury. Life support devices or systems are devices or systems that (a) are intended for
surgical implant into the body or (b) support or sustain life, and whose failure to perform can be reasonably expected to result in a significant
injury to the user. A Purchaser’s use or sale of Micrel Products for use in life support appliances, devices or systems is a Purchaser’s own risk
and Purchaser agrees to fully indemnify Micrel for any damages resulting from such use or sale.
© 2007 Micrel, Incorporated.
November 2007
11 M9999-111507-C
[email protected] or (408) 955-1690

11 Page







PáginasTotal 11 Páginas
PDF Descargar[ Datasheet SY88309BL.PDF ]




Hoja de datos destacado

Número de piezaDescripciónFabricantes
SY88309BL3.2Gbps PECL Limiting Post AmplifierMicrel Semiconductor
Micrel Semiconductor

Número de piezaDescripciónFabricantes
SLA6805M

High Voltage 3 phase Motor Driver IC.

Sanken
Sanken
SDC1742

12- and 14-Bit Hybrid Synchro / Resolver-to-Digital Converters.

Analog Devices
Analog Devices


DataSheet.es es una pagina web que funciona como un repositorio de manuales o hoja de datos de muchos de los productos más populares,
permitiéndote verlos en linea o descargarlos en PDF.


DataSheet.es    |   2020   |  Privacy Policy  |  Contacto  |  Buscar