DataSheet.es    


PDF TM150XG-26L10D Data sheet ( Hoja de datos )

Número de pieza TM150XG-26L10D
Descripción TFT Color LCD Module
Fabricantes Sanyo　
Logotipo Sanyo Logotipo



Hay una vista previa y un enlace de descarga de TM150XG-26L10D (archivo pdf) en la parte inferior de esta página.


Total 18 Páginas

No Preview Available ! TM150XG-26L10D Hoja de datos, Descripción, Manual


1 page




TM150XG-26L10D pdf
[ Note 7 ] Measurement points
1/6Hp 1/2Hp 5/6Hp
1/6Vp
1/2Vp
5/6Vp
12
3
45
Active area
Vp: Total Number of Vertical pixel
Hp: Total Number of horizontal pixel
[ Note 8 ] Measurement condition
(1) Measurement equipment: BM-5A (TOPCON Corp.), Field=2°
(2) Ambient temperature Ta: 25 ± 2°C
(3) LCD: All pixels are WHITE, VDD=3.3V, fV=60Hz
(4) Measure after 30 minutes of CFL warm up.
(5) IL=6.0 mArms with the CFL inverter CFP-102 (TORiSAN)
BACKLIGHT CHARACTERISTICS
This module is used the backlight with 4 CFL.
Please follow the characteristics of 1 CFL as below.
ITEM
Lamp voltage
Lamp current
Operating frequency
Start up voltage
Operating life
SYM. CONDITIOS
VL
IL
fL
VS
tOL
MIN
-
3
-
-
50000
TYP
570
-
55
-
-
MAX
-
6
-
1500
-
UNIT
Vrms
mArms
kHz
Vrms
Hours
Ta=25°C
NOTE
at IL=6.0mArms
(Recommended value)
(Recommended value)
at Ta=0ºC
at IL=6.0 mArms
[ Note 1 ] Backlight driving conditions (operating frequency fL especially) may interfere with
horizontal frequency fH, causing the beat or flicker on the display. Therefore the
operating frequency fL shall be adjusted in relation to horizontal frequency fH to
avoid interference. And please make sure that frequency, phase of Drive voltage
and current of four lamps, match each other.
[ Note 2 ] The inverter open voltage should be larger than start up voltage, otherwise
backlight may blinking for a moment after turns on or not be turned on. And this
voltage should be applied to lamp for more than 1 second to start up, otherwise
backlight may not be turned on.
[ Note 3 ] If driving current waveform is asymmetrical, mercury deviation inside of CFL will
incline to one side and consequently abnormal lighting may occur. To prevent such
unfavorable lighting, driving current waveform is asked to have unbalance rate of
less than 10% and wave-height rate of less than √2 ± 10%.
And this driving waveform shall be confirmed in your system.
Ip
I-p
Current waveform
Unbalance rate = | Ip - I-p | / IL × 100 (%)
Wave-height rate = Ip (or I-p) / IL
Ip : High peak value
I-p : Low peak value
IL : Effective value
[ Note 4 ] The inverter of ground reference type should be used. The inverter of ground
floating type should not be used.
SANYO Electric Co., Ltd.
TM150XG-26L10D Ver.2 Page 4/17

5 Page





TM150XG-26L10D arduino
RELATIONSHIP BETWEEN INPUT DATA AND DISPLAY COLOR
INPUT DATA
R DATA
G DATA
B DATA
DISPLAY
MSB
LSB MSB
LSB MSB
LSB
COLOR
R7 R6 R5 R4 R3 R2 R1 R0 G7 G6 G5 G4 G3 G2 G1 G0 B7 B6 B5 B4 B3 B2 B1 B0
BLACK
L L L L L L L LL LL L L L L LL L L L L L LL
RED
HH HHHHHHL L L L L L L LL L L L L L L L
GREEN
L L L L L L L LHHH HHHHHL L L L L L L L
BLUE
L L L L L L L LL L L L L L L LHH HHHHHH
CYAN
L L L L L L L LH HH H H H H HH H H H H H HH
MAGENTA
HH HHHHHHL L L L L L L LHH HHHHHH
YELLOW
H H H H H H H HH HH H H H H HL L L L L L L L
WHITE
H H H H H H H HH HH H H H H HH H H H H H HH
BLACK
L L L L L L L LL LL L L L L LL L L L L L LL
RED(1)
* L L L L L L L HL L L L L L L LL L L L L L L L
RED(2)
* L L L L L LHLL LL L L L L LL L L L L L LL
RED(3)
* L L L L L L HHL L L L L L L LL L L L L L L L
RED(4)
L L L L LHL LL LL L L L L LL L L L L L LL
:: : :
RED(251) * H H H H H L H H L L L L L L L L L L L L L L L L
H H HHHH L LLL L L L L L LL L L L L L L L
RED(252)
H H HHHH L HLL L L L L L LL L L L L L L L
H H HHHHH LLL L L L L L LL L L L L L L L
H H HHHHHHLL L L L L L LL L L L L L L L
BLACK
L L LL L L L LLL L L L L L LL L L L L L L L
GREEN(1) * L L L L L L L L L L L L L L L H L L L L L L L L
GREEN(2) * L L L L L L L L L L L L L L H L L L L L L L L L
GREEN(3) * L L L L L L L L L L L L L L H H L L L L L L L L
GREEN(4)
L L LL L L L LLL L L LHL LL L L L L L L L
:: : :
GREEN(251) * L L L L L L L L H H H H H L H H L L L L L L L L
L L L L L L L L HH H H H H L L L L L L L L L L
GREEN(252)
L L L L L L L L HH H H H H L H L L L L L L L L
L L L L L L L L HH H H H H H L L L L L L L L L
L L L L L L L L HH H H H H H H L L L L L L L L
BLACK
L L LL L L L LLL L L L L L LL L L L L L L L
BLUE(1)
* L L LL L L L LLL L L L L L LL L L L L L LH
BLUE(2)
* L L LL L L L LLL L L L L L LL L L L L LHL
BLUE(3)
* L L LL L L L LLL L L L L L LL L L L L L HH
BLUE(4)
L L LL L L L LLL L L L L L LL L L L LHL L
:: : :
BLUE(251) * L L L L L L L L L L L L L L L L H H H H H L H H
L L LL L L L LLL L L L L L LHHHHHHL L
BLUE(252)
L L LL L L L LLL L L L L L LHHHHHHLH
L L LL L L L LLL L L L L L LHHHHHHHL
L L LL L L L LLL L L L L L L HHHHHHHH
[ Note 1 ] Color(n) --- 'n' indicates gray scale step.
[ Note 2 ] '*' Mark shows using the frame rate modulation and dithering.
SANYO Electric Co., Ltd.
TM150XG-26L10D Ver.2 Page 10/17

11 Page







PáginasTotal 18 Páginas
PDF Descargar[ Datasheet TM150XG-26L10D.PDF ]




Hoja de datos destacado

Número de piezaDescripciónFabricantes
TM150XG-26L10TFT Color LCD ModuleTORiSAN
TORiSAN
TM150XG-26L10DTFT Color LCD ModuleSanyo
Sanyo

Número de piezaDescripciónFabricantes
SLA6805M

High Voltage 3 phase Motor Driver IC.

 Sanken
Sanken
SDC1742

12- and 14-Bit Hybrid Synchro / Resolver-to-Digital Converters.

 Analog Devices
Analog Devices


DataSheet.es es una pagina web que funciona como un repositorio de manuales o hoja de datos de muchos de los productos más populares,
permitiéndote verlos en linea o descargarlos en PDF.


DataSheet.es    |   2020   |  Privacy Policy  |  Contacto  |  Buscar