DataSheet.es    


PDF MP2207 Data sheet ( Hoja de datos )

Número de pieza MP2207
Descripción 1.3MHz Synchronous Step-Down Converter
Fabricantes MPS 
Logotipo MPS Logotipo



Hay una vista previa y un enlace de descarga de MP2207 (archivo pdf) en la parte inferior de esta página.


Total 14 Páginas

No Preview Available ! MP2207 Hoja de datos, Descripción, Manual

The Future of Analog IC Technology
DESCRIPTION
The MP2207 is an internally compensated
1.3MHz fixed frequency PWM synchronous
step-down regulator with a 3V to 6V bias supply
(VCC). MP2207 operates from a 3V to 16V input
and generates an adjustable output voltage
from 0.8V to 0.9xVIN at up to 4A load current.
The MP2207 integrates an 80mhigh-side
switch and an 80msynchronous rectifier for
high efficiency without an external Schottky
diode. With peak current mode control and
internal compensation, it is stable with a output
ceramic capacitor and a small inductor. Fault
protection includes hiccup short-circuit
protection, cycle-by-cycle current limiting and
thermal shutdown. Other features include
frequency synchronization and internal soft-
start.
The MP2207 is available in small 3mm x 3mm
10-lead QFN and SOIC8E packages.
MP2207
16V, 4A, 1.3MHz Synchronous
Step-Down Converter
FEATURES
4A Output Current
Input Supply Range: 3V to 16V
80mInternal Power MOSFET Switches
All Ceramic Output Capacitors Design
Up to 95% Efficiency
1.3MHz Fixed Switching Frequency
Adjustable Output from 0.8V to 0.9xVIN
Internal Soft-Start
Frequency Synchronization Input
Thermal Shutdown
Cycle-by-Cycle Current Limiting
Hiccup Short Circuit Protection
10-lead, 3mm x 3mm QFN and SOIC8E
Packages.
APPLICATIONS
µP/ASIC/DSP/FPGA Core and I/O Supplies
Printers and LCD TVs
Network and Telecom Equipment
Point of Load Regulators
“MPS” and “The Future of Analog IC Technology” are Trademarks of Monolithic
Power Systems, Inc.
TYPICAL APPLICATION
VIN
3V to 16V
VCC
2.5V to 6V
OFF ON
C1
33uF
C4
1uF
4, 7
IN
6
VCC
5
BS
SW
3, 8
MP2207
10
EN/SYNC
GND
1
FB
2, 9
C3
100nF
L1
1uH
VOUT
1.8V / 4A
C2
47uF
MP2207 Rev. 0.92
www.MonolithicPower.com
9/1/2010
MPS Proprietary Information. Unauthorized Photocopy and Duplication Prohibited.
Preliminary Specifications Subject to Change
© 2010 MPS. All Rights Reserved.
1
Free Datasheet http://www.datasheet4u.com/

1 page




MP2207 pdf
MP2207 – 16V, 4A, 1.3MHz SYNCHRONOUS STEP-DOWN CONVERTER
TYPICAL PERFORMANCE CHARACTERISTICS
VCC = 5V, VOUT = 1.8V, TA = +25ºC, unless otherwise noted.
MP2207 Rev. 0.92
www.MonolithicPower.com
9/1/2010
MPS Proprietary Information. Unauthorized Photocopy and Duplication Prohibited.
Preliminary Specifications Subject to Change
© 2010 MPS. All Rights Reserved.
5
Free Datasheet http://www.datasheet4u.com/

5 Page





MP2207 arduino
MP2207 – 16V, 4A, 1.3MHz SYNCHRONOUS STEP-DOWN CONVERTER
PCB LAYOUT
PCB layout is very important to achieve stable
operation. It is highly recommended to duplicate
EVB layout for optimum performance. If change
is necessary, please follow these guidelines as
follows. Here, the typical application circuit is
taken as an example to illustrate the key layout
rules should be followed.
1) For MP2207, a PCB layout with >=4 layers is
recommended.
2) The high current paths (GND, IN and SW)
should be placed very close to the device with
short, direct and wide traces.
3) Two input ceramic capacitors (10μF~22μF)
are strongly recommended to be placed on both
sides of the MP2207DQ package and keep them
as close as possible to the “IN” and “GND” pins.
4) A RC low pass filter is recommended for VCC
supply. The Vcc decoupling capacitor must be
placed as close as possible to “VCC” pin and
“GND” pin.
5) The external feedback resistors shall be
placed next to the FB pin. Keep the FB trace as
short as possible.
6) Keep the switching node SW short and away
from the feedback network.
Top Layer
Inner Layer 1
Inner Layer 2
Bottom Layer
Figure 2 —Recommended PCB Layout
MP2207 Rev. 0.92
www.MonolithicPower.com
9/1/2010
MPS Proprietary Information. Unauthorized Photocopy and Duplication Prohibited.
Preliminary Specifications Subject to Change
© 2010 MPS. All Rights Reserved.
11
Free Datasheet http://www.datasheet4u.com/

11 Page







PáginasTotal 14 Páginas
PDF Descargar[ Datasheet MP2207.PDF ]




Hoja de datos destacado

Número de piezaDescripciónFabricantes
MP2205A1.3MHz Synchronous Step-Down ConverterMPS
MPS
MP22071.3MHz Synchronous Step-Down ConverterMPS
MPS
MP2208600kHz Synchronous Step-Down ConverterMPS
MPS
MP2209600kHz Synchronous Step-Down ConverterMPS
MPS

Número de piezaDescripciónFabricantes
SLA6805M

High Voltage 3 phase Motor Driver IC.

Sanken
Sanken
SDC1742

12- and 14-Bit Hybrid Synchro / Resolver-to-Digital Converters.

Analog Devices
Analog Devices


DataSheet.es es una pagina web que funciona como un repositorio de manuales o hoja de datos de muchos de los productos más populares,
permitiéndote verlos en linea o descargarlos en PDF.


DataSheet.es    |   2020   |  Privacy Policy  |  Contacto  |  Buscar