|
|
PDF SC630A Data sheet ( Hoja de datos )
| Número de pieza | SC630A | |
| Descripción | 1MHz Fixed 3.3V Output Charge Pump Regulator | |
| Fabricantes | Semtech | |
| Logotipo |  |
|
Hay una vista previa y un enlace de descarga de SC630A (archivo pdf) en la parte inferior de esta página. Total 15 Páginas | ||
|
No Preview Available !
POWER MANAGEMENT
Features
Input voltage range — 2.95V to 5.5V
VOUT tolerance — 3.3V ±3%
Continuous output current — 300mA max
Three charge pump modes — 1x, 1.5x and 2x
Output ripple voltage — 33mVPP , typical
Short circuit, over-voltage, and over-temperature
protection
Soft-start functionality
Shutdown current — 0.1µA, typical
Ultra thin package — 2 x 2 x 0.6 (mm)
Lead-free and halogen-free
WEEE and RoHS compliant
Applications
Mobile phones
Tablets
USB On-The-Go
Multi-LED backlit LCDs
Compact flash/CF+ products
Digital video cameras
DVI/HDMI ports
Wi-Fi base stations
Modems
Set-top boxes
SC630A
1MHz Fixed 3.3V Output
Charge Pump Regulator
Description
The SC630A is a high-current voltage regulator using
Semtech’s proprietary low-noise charge pump technol-
ogy. The charge pump provides a low EMI solution
compared to inductive boost regulators. Performance is
optimized for use in single Li-Ion battery cell applications.
The regulator provides the performance of a linear, low
drop-out (LDO) voltage regulator when the battery is
greater than 3.3V. Unlike an LDO, drop-out is avoided
when the battery is less than 3.3V. Instead, a charge pump
is activated to provide voltage boost and the head-room
needed for regulation.
The SC630A’s charge pump has three modes of operation:
2x, 1.5x, and 1x modes. The 2x and 1.5x modes deliver
current to the load in each of two phases. The 1x mode
turns off the charge pump, delivering current through an
LDO. Hysteresis is provided to prevent chatter between
charge pump modes. When active, the charge pump pro-
vides low-ripple operation at 1MHz. Typically the output
ripple is 1% of the output voltage — 33mVpp at 215mA.http://www.DataSheet4U.net/
A small 2.2µF capacitor is recommended for all four capaci-
tors. The full rated output current is provided when 2.2µF
is used for both bucket capacitors. At the output, a 2.2µF
capacitor decouples the load and provides smoothing for
mode transitions, while another 2.2µF is used to decouple
the input.
Typical Application Circuit
VBAT
CIN IN
2.2µF
OUT
VOUT = 3.3V @ 300mA
COUT
2.2µF
SC630A
Chip
enable
EN
GND
C1+
C1-
C2+
C2-
C1
2.2µF
C2
2.2µF
Rev. 1.1
© 2011 Semtech Corporation
US Patent: 7,808,220
datasheet pdf - http://www.DataSheet4U.net/
1 page  
SC630A
Typical Characteristics
Load Regulation
-25 VOUT = 3.3V, VIN = 3.6V
-20
-15
TA=85°C
-10 TA=25°C
TA=-40°C
-5
0
0 50 100 150 200 250 300 350
Output Current (mA)
Efficiency versus Load Current
100 VOUT = 3.3V
90
80
VIN = 3.4V
VIN = 3.6V
VIN = 3.8V
VIN = 4.0V
70
60
50
0
50 100 150 200 250 300 350
Load Current (mA)
PSRR — 1.5x Mode
0 VIN = 3.2V, VOUT = 3.3V, IOUT = 50mA
-10
CIN = COUT = C1 = C2= 2.2µF (0603)
-20
-30
-40
-50
-60
-70
-80
-90
-100
10
100 1000
Frequency (Hz)
10000
Line Regulation
VOUT = 3.3V, IOUT = 1mA
20
15
10
5
0
-5
85°C
25°C
-40°C
PSRR — 1x Mode
-10
-15
-20
2.7 3.1 3.5 3.9 4.3 4.7 5.1 5.5
Input Voltage (V)
Output Ripple
100 VOUT = 3.3V, CIN = COUT = C1 = C2 = 2.2µf (0603)
80
1.5x and 2x mode
http://www.DataSheet4U.net/
60
40
20
0
5.6
5.2
300mA
200mA
100mA
50mA
1x mode
10mA
4.8 4.4 4.0 3.6 3.2 2.8
Input Voltage (V)
PSRR — 1x Mode
0 VIN = 4.2V, VOUT = 3.3V, IOUT = 50mA
-10
CIN = COUT = C1 = C2= 2.2µF (0603)
-20
-30
-40
-50
-60
-70
-80
-90
-100
10
100 1000
Frequency (Hz)
10000
datasheet pdf - http://www.DataSheet4U.net/
5 Page 
SC630A
Applications Information (continued)
Over-Temperature Protection
The over-temperature circuit helps prevent the device
from overheating and experiencing a catastrophic failure.
When the junction temperature exceeds 165°C the device
is disabled. It remains disabled until the junction tempera-
ture drops below this threshold. Hysteresis is included
that prevents the device from re-enabling until the junc-
tion temperature is reduced by 20°C.
Capacitor Selection
The SC630A is designed to use low-ESR ceramic capacitors
for the input and output bypass capacitors as well as the
charge pump bucket capacitors. The value of input, output
and decoupling capacitors will vary with system require-
ments for ripple and output current. Performance as
shown in the Typical Characteristic section is expected
when using 2.2µF capacitors in the 0603(1608 metric) case
size with X5R dielectric for CIN , COUT , C1 and C2 capacitors
(refer to Table 1).
Consider the DC voltage characteristic of the capacitor
when choosing capacitors for an application. The value of
capacitance at the DC operating voltage may be consider-
ably lower than the rated value. The following table lists
recommended capacitor values which have been chosen
to minimize the impact of this limitation.
The highest capacitance values in the smallest package
sizes tend to have poor DC voltage characteristics. The
highest value 0402 size capacitor retains as little as 35% of
its rated value at 5VDC. The same value chosen in the next
larger package size, 0603, will retain about 60% of its rated
value at 5VDC.
Table 1 — Recommended Capacitors
Size Code
mil(mm)
Value
μF
Capacitor
Notes
0603(1608)
CIN , COUT
2.2
C1, C2
0402(1005)
CIN , COUT
2.2
C1, C2
0402(1005)
0.47
CIN , COUT
C1, C2
1.0 CIN , COUT
0402(1005)http://www.DataSheet4U.net/
0.1 C1, C2
This capacitor is required for
the full rated output current.
Typical output VPP < 100mV
in all charge pump modes.
This capacitor combina-
tion supports up to 200mA
output current with typical
output VPP < 100mV in all
charge pump modes.
This capacitor combina-
tion supports up to 100mA
output current with typical
output VPP < 100mV in all
charge pump modes.
This combination of capaci-
tors support up to 100mA
output current with typical
output VPP < 100mV in all
charge pump modes.
The 0.1µF bucket capacitors
will increase output resis-
tance by 2.5Ω compared to
0.47µF and larger values.
NOTE: Use only X5R type capacitors, with a 6.3V rating or higher
11
datasheet pdf - http://www.DataSheet4U.net/
11 Page | ||
| Páginas | Total 15 Páginas | |
| PDF Descargar | [ Datasheet SC630A.PDF ] | |
Hoja de datos destacado
| Número de pieza | Descripción | Fabricantes |
| SC630 | Fixed 3.3V High Output Charge Pump Buck/Boost Regulator | Semtech |
| SC630A | 1MHz Fixed 3.3V Output Charge Pump Regulator | Semtech |
| Número de pieza | Descripción | Fabricantes |
| SLA6805M | High Voltage 3 phase Motor Driver IC. |
 Sanken |
| SDC1742 | 12- and 14-Bit Hybrid Synchro / Resolver-to-Digital Converters. |
 Analog Devices |
|
DataSheet.es es una pagina web que funciona como un repositorio de manuales o hoja de datos de muchos de los productos más populares, |
| DataSheet.es | 2020 | Privacy Policy | Contacto | Buscar |