|
|
Número de pieza | LV8483CS | |
Descripción | Composite Channel Lens Driver | |
Fabricantes | Sanyo Semicon Device | |
Logotipo | ||
Hay una vista previa y un enlace de descarga de LV8483CS (archivo pdf) en la parte inferior de esta página. Total 9 Páginas | ||
No Preview Available ! www.DataSheet.co.kr
Ordering number : ENA1609
LV8483CS
Bi-CMOS IC
For Camera Modules
Composite Channel Lens Driver
Overview
LV8483CS is a constant current driver IC for voice coil motors (VCM) that includes a constant current 1.5-channel driver.
It uses an ultraminiature wafer level package (WLP), which makes the IC ideal for VCM motor, shutter (SH), and iris (IR)
drivers used in a wide variety of portable equipment including camera cell phones.
Functions
• Constant current driver for AF VCM + constant current 1.5-channel H-bridge driver for SH and IR
• I2C bus interface
• Low power consumption achieved using MOS process technologies
• Built-in 4-bit DAC for constant current operation (used for SH and IR H-bridges)
• Built-in 10-bit DAC for constant current control (used for AF VCM driver)
• Built-in constant current detection resistance
• Wafer level package. WLP10 (0.97mm × 2.47mm × 0.5mmt)
• Built-in thermal shutdown circuit and LVS circuit.
• AF VCM overshoot prevention function (current slope function)
• Built-in SH/IR control pin (energization timing control function using trigger input)
Specifications
Absolute Maximum Ratings at Ta = 25°C
Parameter
Symbol
Conditions
Maximum supply voltage
Output applied voltage
Input applied voltage
GND pin flow-out current
VCC max
VOUT max
VIN max
IGND
OUT1, OUT2, OUT3, OUT4
ENA, SCL, SDA, SH/IRTR
Per channel
Allowable power dissipation
Pd max
With specified substrate *
Operating temperature
Topr
Storage temperature
Tstg
* Specified substrate : 50mm × 50mm × 1.6mm, glass epoxy 2-layer board
Ratings
5.0
5.0
-0.3 to +5.0
400
550
-30 to +85
-40 to +150
Unit
V
V
V
mA
mW
°C
°C
Any and all SANYO Semiconductor Co.,Ltd. products described or contained herein are, with regard to
"standard application", intended for the use as general electronics equipment (home appliances, AV equipment,
communication device, office equipment, industrial equipment etc.). The products mentioned herein shall not be
intended for use for any "special application" (medical equipment whose purpose is to sustain life, aerospace
instrument, nuclear control device, burning appliances, transportation machine, traffic signal system, safety
equipment etc.) that shall require extremely high level of reliability and can directly threaten human lives in case
of failure or malfunction of the product or may cause harm to human bodies, nor shall they grant any guarantee
thereof. If you should intend to use our products for applications outside the standard applications of our
customer who is considering such use and/or outside the scope of our intended standard applications, please
consult with us prior to the intended use. If there is no consultation or inquiry before the intended use, our
customer shall be solely responsible for the use.
Specifications of any and all SANYO Semiconductor Co.,Ltd. products described or contained herein stipulate
the performance, characteristics, and functions of the described products in the independent state, and are not
guarantees of the performance, characteristics, and functions of the described products as mounted in the
customer's products or equipment. To verify symptoms and states that cannot be evaluated in an independent
device, the customer should always evaluate and test devices mounted in the customer's products or
equipment.
31710 SY PC 20091013-S00004 No.A1609-1/9
Datasheet pdf - http://www.DataSheet4U.net/
1 page www.DataSheet.co.kr
LV8483CS
Serial Bus Communication Specifications
I2C serial transfer timing conditions
Standard mode
twH
SCL
ts1
SDA
th1
twL
th2
ts2
Start condition
ton
toff
tbus
ts3
Stop condition
Input waveform condition
Standard mode
Parameter
SCL clock frequency
Data setup time
Data hold time
Pulse width
Input waveform conditions
Bus free time
symbol
fscl
ts1
ts2
ts3
th1
th2
twL
twH
ton
toff
tbus
Conditions
SCL clock frequency
Setup time of SCL with respect to the falling edge of SDA
Setup time of SDA with respect to the rising edge of SCL
Setup time of SCL with respect to the rising edge of SDA
Hold time of SCL with respect to the falling edge of SDA
Hold time of SDA with respect to the falling edge of SCL
SCL low period pulse width
SCL high period pulse width
SCL, SDA rising time
SCL, SDA falling time
Interval between stop condition and start condition
min
0
4.7
250
4.0
4.0
0
4.7
4.0
4.7
typ
High-speed mode
Parameter
SCL clock frequency
Data setup time
Data hold time
Pulse width
Input waveform conditions
Bus free time
Symbol
fscl
ts1
ts2
ts3
th1
th2
twL
twH
ton
toff
tbus
Conditions
SCL clock frequency
Setup time of SCL with respect to the falling edge of SDA
Setup time of SDA with respect to the rising edge of SCL
Setup time of SCL with respect to the rising edge of SDA
Hold time of SCL with respect to the falling edge of SDA
Hold time of SDA with respect to the falling edge of SCL
SCL low period pulse width
SCL high period pulse width
SCL, SDA (input) rising time
SCL, SDA (input) falling time
Interval between stop condition and start condition
min
0
0.6
100
0.6
0.6
0
1.3
0.6
1.3
typ
max
100
1000
300
unit
kHz
μs
ns
μs
μs
μs
μs
μs
ns
ns
μs
max
400
300
300
unit
kHz
μs
ns
μs
μs
μs
μs
μs
ns
ns
μs
No.A1609-5/9
Datasheet pdf - http://www.DataSheet4U.net/
5 Page |
Páginas | Total 9 Páginas | |
PDF Descargar | [ Datasheet LV8483CS.PDF ] |
Número de pieza | Descripción | Fabricantes |
LV8483CS | Composite Channel Lens Driver | Sanyo Semicon Device |
Número de pieza | Descripción | Fabricantes |
SLA6805M | High Voltage 3 phase Motor Driver IC. |
Sanken |
SDC1742 | 12- and 14-Bit Hybrid Synchro / Resolver-to-Digital Converters. |
Analog Devices |
DataSheet.es es una pagina web que funciona como un repositorio de manuales o hoja de datos de muchos de los productos más populares, |
DataSheet.es | 2020 | Privacy Policy | Contacto | Buscar |