|
|
PDF B44066T0010E402 Data sheet ( Hoja de datos )
| Número de pieza | B44066T0010E402 | |
| Descripción | Thyristor module TSM-LC10 | |
| Fabricantes | EPCOS | |
| Logotipo |  |
|
Hay una vista previa y un enlace de descarga de B44066T0010E402 (archivo pdf) en la parte inferior de esta página. Total 6 Páginas | ||
|
No Preview Available !
www.DataSheet4U.com
Thyristor module TSM-LC10
Series/Type: TSM
Ordering code: B44066T0010E402
Date:
Version:
November 2006
1
Content of inside pages of data sheet. Data will be automatically entered into frontpage
headlines, headers and footers. Please fill in the table and then change the colour to “White”.
This ensures that the table disappears for the customer pdf.
Identification/Classification 1:
(header 1)
Thyristor module for dynamic PFC
Identification/Classification 2:
(header 2)
Accessories for power factor correction
Ordering code:
B44066T0010E402
Series/Type:
Thyristor module TSM-LC10
Preliminary data (optional):
(if necessary)
Preliminary data
Department:
FK PC PM PFC
Date:
November 2006
© EPCOS AG 2006. Reproduction, publication and dissemination of this data sheet, enclosures hereto and the information
contained therein without EPCOS' prior express consent is prohibited.
1 page  
Thyristor module for dynamic PFC
wAwcw.cDeatsaSshoeerti4eUs.cofmor power factor correction
Preliminary data
Cautions and Warnings
B44066T0010E402
Thyristor module TSM-LC10
General
• Thyristor modules TSM series may only be used for the purpose they have been designed for.
• Thyristor modules TSM series may only be used in combination with appropriate pre-switched grid
separator device.
• Thyristor modules have to be projected in such a way that in case of any failure no uncontrolled
high current and voltages may occur.
• The devices in operation have to be protected against moisture and dust, sufficient cooling has to
be assured.
Attention
Due to the switching principle of the thyristor module the power capacitors are permanently loaded to
the peak value of the grid voltage (DC voltage) even when switched off. Therefore following rules
have to be obeyed in any case:
• For standard PFC-systems (without reactors) power capacitors of 440 V nominal voltage have to
be used; for detuned systems PFC capacitors of 525 V nominal voltage have to be used.
• Due to the high voltage (2 x peak value of nominal voltage) that occurs, the discharge resistors of
the power capacitors have to be replaced by special types (accessory EW22).
• In dynamic systems with TSM modules no fast discharge reactors may be used (reactor = DC-
wise short circuit).
• For standard PFC-systems 2 current limiting reactors are mandatory per thyristor module
(accessory BD100).
• Thyristor modules in general have to be protected by superfast electronic fuses. Principles for
dimensioning have to be considered. Fuses in the system have to be marked.
• Due to the special switching, the PFC capacitors are fully loaded even when the particular step
has been switched off. Protection against contact has to be guaranteed. Warning signals in the
systems are required.
• Even in switched off state no electrical isolation is achieved for electronic switches. Therefore
parts of the systems may not be touched after switching off the complete system before the
capacitors have been completely discharged.
FAILURE TO FOLLOW CAUTIONS MAY RESULT, WORST CASE, IN PREMATURE FAILURES OR
PHYSICAL INJURY.
U Please read cautions information about PFC capacitors and cautions as well as installation and maintenance instructions in the actual
version of the Product Profile Power Factor Correction to ensure optimum performance and prevent products from failing, and in worst case,
bursting and fire, etc. The actual Product Profile is available at www.epcos.com/publications.
Information given in the PFC-product profile and values given in the data sheet reflect typical specifications. You are kindly requested to
approve our product specifications or request our approval for your specification before ordering.
FK PC PM PFC
Please read Cautions and warnings and
Important notes at the end of this document.
Page 5 of 6
November 2006
5 Page | ||
| Páginas | Total 6 Páginas | |
| PDF Descargar | [ Datasheet B44066T0010E402.PDF ] | |
Hoja de datos destacado
| Número de pieza | Descripción | Fabricantes |
| B44066T0010E402 | Thyristor module TSM-LC10 | EPCOS |
| Número de pieza | Descripción | Fabricantes |
| SLA6805M | High Voltage 3 phase Motor Driver IC. |
 Sanken |
| SDC1742 | 12- and 14-Bit Hybrid Synchro / Resolver-to-Digital Converters. |
 Analog Devices |
|
DataSheet.es es una pagina web que funciona como un repositorio de manuales o hoja de datos de muchos de los productos más populares, |
| DataSheet.es | 2020 | Privacy Policy | Contacto | Buscar |