DataSheet.es    


PDF APL1117 Data sheet ( Hoja de datos )

Número de pieza APL1117
Descripción 1A Low Dropout Fast Response Positive Adjustable Regulator
Fabricantes Anpec Electronics 
Logotipo Anpec Electronics Logotipo



Hay una vista previa y un enlace de descarga de APL1117 (archivo pdf) en la parte inferior de esta página.


Total 18 Páginas

No Preview Available ! APL1117 Hoja de datos, Descripción, Manual

www.DataSheet4U.com
APL1117
1A Low Dropout Fast Response Positive Adjustable Regulator and Fixed
1.8V, 2.5V, 2.85V and 3.3V
Features
General Description
Guaranteed Output Voltage Accuracy within 2% The APL1117 is a low dropout three-terminal adjust-
able regulators with 1A output current capability. In
Fast Transient Response
order to obtain lower dropout voltage and faster tran-
Guaranteed Dropout Voltage at Multiple
Currents
sient response, which is critical for low voltage ap-
plications , the APL1117 has been optimized. The
device is available in an adjustable version and fixed
Load Regulation : 0.1% Typ.
Line Regulation : 0.03% Typ.
output voltages of 1.8V, 2.5V, 2.85V and 3.3V. The
output available voltage range of an adjustable ver-
sion is from 1.25~10.7V with an input supply below
Low Dropout Voltage : 1.1V Typ. at IOUT =1A
Current Limit : 1A Typ. at TJ=25°C
12V. Dropout voltage is guaranteed at a maximum of
1.3V at 1A. Current limit is trimmed to ensure speci-
fied output current and controlled short-circuit current.
On-Chip Thermal Limiting : 150°C Typ.
Adjustable Output : 1.25~10.7V
On-chip thermal limiting provides protection against
any combination of overload that would create exces-
sive junction temperatures. The APL1117 is available
Standard 3-pin TO-220, TO-252, TO-263 and
SOT-223 Power Packages
in the industry standard 3-pin TO-220, TO-252, TO-
263, and the low profile surface mount SOT-223
power packages which can be used in applications
where space is limited.
Applications
Pin Description
Active SCSI Terminators
Low Voltage Logic Supplies
Battery-Powered Circuitry
Post Regulator for Switching Power Supply
Front View for TO-220
3V
IN
2V
OUT
1 ADJ/GND
Front View for TO-263
TAB is VOUT
3 VIN
2
V
OUT
1 ADJ/GND
Front View for TO-252
3
V
IN
TAB IS V
OUT
2V
OUT
1 ADJ/GND
ANPEC reserves the right to make changes to improve reliability or manufacturability without notice, and advise
customers to obtain the latest version of relevant information to verify before placing orders.
Copyright ANPEC Electronics Corp.
Rev. B.8 - Jun., 2003
1
www.anpec.com.tw

1 page




APL1117 pdf
www.DataSheet4U.com
APL1117
Application Circuits
1.25V to 10.7V Adjustable Regulator
Improving Ripple Rejection
APL1117
VIN IN OUT
ADJ R1
121
+ 10µF
C1*
R2
1k
VOUT1
+ 100µF
C2
* Needed if device is far from filter capacitors
R1 + R2
VOUT = 1.250V X R1
5V Regulator with Shutdown
V IN
+
10µF
APL1117
IN OUT
ADJ
R2
365
1%
* C1 improves ripple rejection.
XC should be approximately
equal to R1 at ripple frequency
R1
121
1%
+ C1
10µF
VOUT
150µ F
APL1117
VIN IN OUT
ADJ
+
10µF
1k
TTL
1k
121
1%
+
365
1%
5V
100µF
Copyright ANPEC Electronics Corp.
Rev. B.8 - Jun., 2003
5
www.anpec.com.tw

5 Page





APL1117 arduino
www.DataSheet4U.com
APL1117
Application Information (Cont.)
Thermal Considerations (Cont.)
60
TA=25°C
55
50
45
40
35
30
0 2 4 6 8 10 12 14
Top Copper Area (cm2)
Figure 4.
θ(J-A) vs. copper area for the SOT-223 package
The thermal resistance for each application will be
affected by thermal interactions with other compo-
nents on the board. Some experimentation will be
necessary to determine the actual value.
The power dissipation of APL1117 is equal to :
PD = (VIN - VOUT) x IOUT
Maximum junction temperature is equal to :
TJUNCTION = TAMBIENT + (PD x θJA)
Note: TJUNCTION must not exceed 125°C
Copyright ANPEC Electronics Corp.
Rev. B.8 - Jun., 2003
11
www.anpec.com.tw

11 Page







PáginasTotal 18 Páginas
PDF Descargar[ Datasheet APL1117.PDF ]




Hoja de datos destacado

Número de piezaDescripciónFabricantes
APL11171A Low Dropout Fast Response Positive Adjustable RegulatorAnpec Electronics
Anpec Electronics
APL1117D1A Low Dropout Fast Response Positive Adjustable RegulatorAnpec Electronics
Anpec Electronics
APL1117R1A Low Dropout Fast Response Positive Adjustable RegulatorAnpec Electronics
Anpec Electronics

Número de piezaDescripciónFabricantes
SLA6805M

High Voltage 3 phase Motor Driver IC.

Sanken
Sanken
SDC1742

12- and 14-Bit Hybrid Synchro / Resolver-to-Digital Converters.

Analog Devices
Analog Devices


DataSheet.es es una pagina web que funciona como un repositorio de manuales o hoja de datos de muchos de los productos más populares,
permitiéndote verlos en linea o descargarlos en PDF.


DataSheet.es    |   2020   |  Privacy Policy  |  Contacto  |  Buscar