|
|
PDF ASM1834A Data sheet ( Hoja de datos )
| Número de pieza | ASM1834A | |
| Descripción | Dual 5V and 3.3V uP Power Supply Supervisor | |
| Fabricantes | Alliance Semiconductor | |
| Logotipo |  |
|
Hay una vista previa y un enlace de descarga de ASM1834A (archivo pdf) en la parte inferior de esta página. Total 10 Páginas | ||
|
No Preview Available !
www.DataSheet4U.com
April 2005
ASM1834/A/D
rev 1.3
Dual 5V and 3.3V µP Power Supply Supervisor with Manual Reset
General Description
The ASM1834 supervisors simultaneously monitor both 3.3V
and 5V power sources and generate reset signals when either
supply is out of tolerance. When an out-of-tolerance condition is
detected, the output-reset signal of the affected supply
becomes active and resets the system microprocessor/
microcontroller. On power-up and after the supply voltage
returns to an in-tolerance condition, the reset signal remains
active for approximately 350ms. This allows the power supply
and system microprocessor to stabilize.
Tolerance levels are independently selectable for both supplies.
Tolerance options are 5% and 10% percent for the 5V supply
and 10% and 20% percent for the 3.3V supply.
The ASM1834 and ASM1834D have push-pull reset output
stages. The ASM1834A reset outputs are open drain devices
that can both be connected to either 5V or 3.3V supply. The
ASM1834 and ASM1834A have active LOW reset outputs. The
ASM1834D has active HIGH reset outputs.
All devices can generate reset signals through an internally
debounced pushbutton reset input that affects both reset
outputs.
All devices operate over the extended industrial temperature
range. Devices are available in 8-pin DIP, surface mount 8-pin
SO and 8-Pin MicroSO packages. Die are also available.
Key Features
• Monitors 5V and 3.3V supplies simultaneously
• 5V and 3.3V power-on reset
• 350ms reset time
• Debounced pushbutton reset input
• Push-pull CMOS output
• ASM1834, ASM1834D
• Eliminates external pull-up resistors
• Active LOW (ASM1834), HIGH (ASM1834D)
• Open Drain Output
• ASM1834A
• Active LOW
• Selectable 5V and 3.3V trip point tolerance
• Internal power drawn from highest input voltage, 5V or
3.3V
• Precision temperature-compensated voltage reference and
comparator
• Low cost surface mount SO, compact MicroSO and DIP
packages.
• Wide operating temperature, -40°C to +85°C
Applications
• Microprocessors
• PDAs, Hand-held PCs
• Embedded Controllers
• Telecommunication Systems
• Power Supplies
• Wireless / Cellular Systems
• Networking Hardware
Typical Operating Circuit
+5V 3.3V
ASM1834
5VIN
3.3VIN
RESET
PBRST
5VTOL GND 3.3VTOL
3.3V 5V
µP
RESET
GND
Alliance Semiconductor
2575 Augustine Drive . Santa Clara, CA 95054 . Tel: 408.855.4900 . Fax: 408.855.4999 . www.alsc.com
Notice: The information in this document is subject to change without notice
1 page  
April 2005
rev 1.3
ASM1834/A/D
5V 3.3V 5V or 3.3V
ASM1834A
1 5VIN
3.3VIN 8
27
5VRESET 3.3VRESET
36
5V TOL
3.3V TOL
4
GND
5
PBRST
10kΩ
Figure 7: ASM1834A Wired “OR” Connection
Trip Point Tolerance Selection
The 3.3VTOL and 5VTOL inputs allow independent selection of
the reset trip points. If 5VTOL is connected to the 5V supply
input, a 10% tolerance is selected. If 5VTOL is grounded, a 5%
tolerance is selected.
If 3.3VTOL is connected to the 3.3V supply input, a 20%
tolerance is selected. If 3.3VTOL is grounded, a 10% tolerance
is selected. (Refer table below). The 3.3VTOL and 5VTOL
tolerance select inputs should be tied to the ground or to the
respective input supply voltage pin, 3.3VIN or 5VIN.
Tolerance Select
5VTOL = 5VIN
5VTOL = GND
3.3VTOL = 3.3VIN
3.3VTOL = GND
3.3V
Tolerance
-
-
20%
10%
3.3V Input
TRIP Point (V)
MIN NOM MAX
-- -
-- -
2.47 2.55 2.64
2.80 2.88 2.97
5V
Tolerance
10%
5%
-
-
5V Input
TRIP Point (V)
MIN NOM MAX
4.25 4.38
4.5 4.63
--
--
4.49
4.75
-
-
Dual 5V and 3.3V µP Power Supply Supervisor with Manual Reset
Notice: The information in this document is subject to change without notice
5 of 10
5 Page | ||
| Páginas | Total 10 Páginas | |
| PDF Descargar | [ Datasheet ASM1834A.PDF ] | |
Hoja de datos destacado
| Número de pieza | Descripción | Fabricantes |
| ASM1834 | Dual 5V and 3.3V uP Power Supply Supervisor | Alliance Semiconductor |
| ASM1834 | Power Supply Supervisor |  ON Semiconductor |
| ASM1834A | Dual 5V and 3.3V uP Power Supply Supervisor | Alliance Semiconductor |
| ASM1834A | Power Supply Supervisor | ON Semiconductor |
| Número de pieza | Descripción | Fabricantes |
| SLA6805M | High Voltage 3 phase Motor Driver IC. |
 Sanken |
| SDC1742 | 12- and 14-Bit Hybrid Synchro / Resolver-to-Digital Converters. |
 Analog Devices |
|
DataSheet.es es una pagina web que funciona como un repositorio de manuales o hoja de datos de muchos de los productos más populares, |
| DataSheet.es | 2020 | Privacy Policy | Contacto | Buscar |