|
|
PDF PS2581L2 Data sheet ( Hoja de datos )
| Número de pieza | PS2581L2 | |
| Descripción | (PS2581L1 / PS2581L2) LONG CREEPAGE TYPE HIGH ISOLATION VOLTAGE 4-PIN PHOTOCOUPLER | |
| Fabricantes | CEL | |
| Logotipo |  |
|
Hay una vista previa y un enlace de descarga de PS2581L2 (archivo pdf) en la parte inferior de esta página. Total 11 Páginas | ||
|
No Preview Available !
www.DataSheet4U.com
PHOTOCOUPLER
PS2581L1,PS2581L2
LONG CREEPAGE TYPE HIGH ISOLATION VOLTAGE
4-PIN PHOTOCOUPLER
−NEPOC Series−
DESCRIPTION
The PS2581L1, PS2581L2 are optically coupled isolators containing a GaAs light emitting diode and an NPN
silicon phototransistor in a plastic DIP (Dual In-line Package).
Creepage distance and clearance of leads are over 8 millimeters.
The PS2581L2 is lead bending type (Gull-wing) for surface mounting.
FEATURES
• Long creepage and clearance distance (8 mm)
• High isolation voltage (BV = 5 000 Vr.m.s.)
• High collector to emitter voltage (VCEO = 80 V)
• High-speed switching (tr = 3 µs TYP., tf = 5 µs TYP.)
• High current transfer ratio (CTR = 200 % TYP.)
• UL approved: File No. E72422 (S)
• CSA approved: No. CA101391
• BSI approved: No. 8243/8244
• NEMKO approved: No. P97103006
• DEMKO approved: No. 307269
• SEMKO approved: No. 9741154/01
• FIMKO approved: No. 018277
• VDE0884 approved
ORDERING INFORMATION (Solder Contains Lead)
Part Number
PS2581L1
PS2581L2
PS2581L2-E3, E4
Package
4-pin DIP
4-pin DIP
(lead bending surface mount)
4-pin DIP taping
Safety Standard Approval
UL, CSA, BSI, NEMKO, DEMKO,
SEMKO, FIMKO, VDE approved
Application Part Number *1
PS2581L1
PS2581L2
*1 As applying to Safety Standard, following part number should be used.
ORDERING INFORMATION (Pb-Free)
Part Number
Package
PS2581L1-A
PS2581L2-A
4-pin DIP
4-pin DIP
(lead bending surface mount)
PS2581L2-E3, E4-A 4-pin DIP taping
Safety Standard Approval
UL, CSA, BSI, NEMKO, DEMKO,
SEMKO, FIMKO, VDE approved
Application Part Number *1
PS2581L1
PS2581L2
*1 As applying to Safety Standard, following part number should be used.
Document No. PN10239EJ01V0DS (1st edition)
(Previous No. P12809EJ2V0DS00)
Date Published February 2003 CP(K)
The mark shows major revised points.
1 page  
PS2581L1,PS2581L2
TYPICAL CHARACTERISTICS (TA = 25 °C, unless otherwise specified)
DIODE POWER DISSIPATION vs.
AMBIENT TEMPERATURE
150
TRANSISTOR POWER DISSIPATION
vs. AMBIENT TEMPERATURE
150
100 100
50 50
0 25 50 75 100 125 150
Ambient Temperature TA (˚C)
FORWARD CURRENT vs.
FORWARD VOLTAGE
100
50
TA = +100 ˚C
+60 ˚C
+25 ˚C
10
5
0 ˚C
–25 ˚C
1 –55 ˚C
0.5
0.1
0.7 0.8 0.9 1.0 1.1 1.2 1.3 1.4 1.5
Forward Voltage VF (V)
COLLECTOR TO EMITTER DARK
CURRENT vs. AMBIENT TEMPERATURE
10 000
1 000
100
VCE = 80 V
40 V
24 V
10 V
5V
10
1
– 50
–25 0 25 50 75
Ambient Temperature TA (˚C)
100
0 25 50 75 100 125 150
Ambient Temperature TA (˚C)
COLLECTOR CURRENT vs.
COLLECTOR TO EMITTER VOLTAGE
70
60
50
40
30
50
mA
20
m10AmA
20 IF = 5 mA
10
0 2 4 6 8 10
Collector to Emitter Voltage VCE (V)
COLLECTOR CURRENT vs.
COLLECTOR SATURATION VOLTAGE
40
50 mA
20 mA
10 mA
10
5 mA
5
2 mA
IF = 1 mA
1
0.5
0.1
0
0.2 0.4 0.6 0.8 1.0
Collector Saturation Voltage VCE(sat) (V)
Data Sheet PN10239EJ01V0DS
5
5 Page 
4590 Patrick Henry Drive
Santa Clara, CA 95054-1817
Telephone: (408) 919-2500
Facsimile: (408) 988-0279
Subject: Compliance with EU Directives
CEL certifies, to its knowledge, that semiconductor and laser products detailed below are compliant
with the requirements of European Union (EU) Directive 2002/95/EC Restriction on Use of Hazardous
Substances in electrical and electronic equipment (RoHS) and the requirements of EU Directive
2003/11/EC Restriction on Penta and Octa BDE.
CEL Pb-free products have the same base part number with a suffix added. The suffix –A indicates
that the device is Pb-free. The –AZ suffix is used to designate devices containing Pb which are
exempted from the requirement of RoHS directive (*). In all cases the devices have Pb-free terminals.
All devices with these suffixes meet the requirements of the RoHS directive.
This status is based on CEL’s understanding of the EU Directives and knowledge of the materials that
go into its products as of the date of disclosure of this information.
Restricted Substance
per RoHS
Lead (Pb)
Mercury
Cadmium
Hexavalent Chromium
PBB
PBDE
Concentration Limit per RoHS
(values are not yet fixed)
< 1000 PPM
< 1000 PPM
< 100 PPM
< 1000 PPM
< 1000 PPM
< 1000 PPM
Concentration contained
in CEL devices
-A
Not Detected
-AZ
(*)
Not Detected
Not Detected
Not Detected
Not Detected
Not Detected
If you should have any additional questions regarding our devices and compliance to environmental
standards, please do not hesitate to contact your local representative.
Important Information and Disclaimer: Information provided by CEL on its website or in other communications concerting the substance
content of its products represents knowledge and belief as of the date that it is provided. CEL bases its knowledge and belief on information
provided by third parties and makes no representation or warranty as to the accuracy of such information. Efforts are underway to better
integrate information from third parties. CEL has taken and continues to take reasonable steps to provide representative and accurate
information but may not have conducted destructive testing or chemical analysis on incoming materials and chemicals. CEL and CEL
suppliers consider certain information to be proprietary, and thus CAS numbers and other limited information may not be available for
release.
In no event shall CEL’s liability arising out of such information exceed the total purchase price of the CEL part(s) at issue sold by CEL to
customer on an annual basis.
See CEL Terms and Conditions for additional clarification of warranties and liability.
11 Page | ||
| Páginas | Total 11 Páginas | |
| PDF Descargar | [ Datasheet PS2581L2.PDF ] | |
Hoja de datos destacado
| Número de pieza | Descripción | Fabricantes |
| PS2581L1 | LONG CREEPAGE TYPE HIGH ISOLATION VOLTAGE 4-PIN PHOTOCOUPLER |  NEC |
| PS2581L1 | (PS2581L1 / PS2581L2) LONG CREEPAGE TYPE HIGH ISOLATION VOLTAGE 4-PIN PHOTOCOUPLER | CEL |
| PS2581L2 | LONG CREEPAGE TYPE HIGH ISOLATION VOLTAGE 4-PIN PHOTOCOUPLER | NEC |
| PS2581L2 | (PS2581L1 / PS2581L2) LONG CREEPAGE TYPE HIGH ISOLATION VOLTAGE 4-PIN PHOTOCOUPLER | CEL |
| Número de pieza | Descripción | Fabricantes |
| SLA6805M | High Voltage 3 phase Motor Driver IC. |
 Sanken |
| SDC1742 | 12- and 14-Bit Hybrid Synchro / Resolver-to-Digital Converters. |
 Analog Devices |
|
DataSheet.es es una pagina web que funciona como un repositorio de manuales o hoja de datos de muchos de los productos más populares, |
| DataSheet.es | 2020 | Privacy Policy | Contacto | Buscar |