|
|
PDF LT1076HV-5 Data sheet ( Hoja de datos )
| Número de pieza | LT1076HV-5 | |
| Descripción | 5V Step-Down Switching Regulator | |
| Fabricantes | Linear Technology | |
| Logotipo |  |
|
Hay una vista previa y un enlace de descarga de LT1076HV-5 (archivo pdf) en la parte inferior de esta página. Total 4 Páginas | ||
|
No Preview Available !
FEATURES
s Fixed 5V Output
s 2A On-Board Switch
s 100kHz Switching Frequency
s 2% Output Voltage Tolerance Over Temperature
s Greatly Improved Dynamic Behavior
s Available in Low Cost 5-Lead Package
s Only 9.5mA Quiescent Current
s Operates Up to 60V Input
APPLICATI S
s 5V Output Buck Converter
s Tapped Inductor Buck Converter with 4A Output
at 5V
s Positive-to-Negative Converter
LT1076-5
5V Step-Down
Switching Regulator
DESCRIPTIO
The LT1076-5 is a 2A fixed 5V output monolithic bipolar
switching regulator which requires only a few external
parts for normal operation. The power switch, all oscillator
and control circuitry, all current limit components, and an
output monitor are included on the chip. The topology is
a classic positive “buck” configuration but several design
innovations allow this device to be used as a positive-to-
negative converter, a negative boost converter, and as a
flyback converter. The switch output is specified to swing
40V below ground, allowing the LT1076-5 to drive a
tapped inductor in the buck mode with output currents up
to 4A.
The LT1076-5 uses a true analog multiplier in the feedback
loop. This makes the device respond nearly instanta-
neously to input voltage fluctuations and makes loop gain
independent of input voltage. As a result, dynamic behav-
ior of the regulator is significantly improved over previous
designs.
On-chip pulse by pulse current limiting makes the LT1076-
5 nearly bust-proof for output overloads or shorts. The
input voltage range as a buck converter is 8V to 60V, but
a self-boot feature allows input voltages as low as 5V in the
inverting and boost configurations.
The LT1076-5 is available in a low cost 5-lead TO-220
package with frequency pre-set at 100kHz and current
limit at 2.6A. See Application Note 44 for design details.
TYPICAL APPLICATI
Basic Positive Buck Converter
8V TO 40V
+
VIN VSW
LT1076-5
GND
C3
200µF
SENSE
VC
R3
1.5k
C2
0.033µF
100µH**†
MBR340*
5V
≤1.8A
* MBR330P MAY BE USED
FOR VIN ≤ 25V
** COILTRONICS #100-1-52
HURRICANE #HL-AG210LL
+ C1
500µF
25V
† VALUE MAY BE REDUCED TO 50µH
FOR OUTPUT LOADS BELOW 1.5A
LT1076-5 TA01
1
1 page | ||
| Páginas | Total 4 Páginas | |
| PDF Descargar | [ Datasheet LT1076HV-5.PDF ] | |
Hoja de datos destacado
| Número de pieza | Descripción | Fabricantes |
| LT1076HV-5 | 5V Step-Down Switching Regulator | Linear Technology |
| Número de pieza | Descripción | Fabricantes |
| SLA6805M | High Voltage 3 phase Motor Driver IC. |
 Sanken |
| SDC1742 | 12- and 14-Bit Hybrid Synchro / Resolver-to-Digital Converters. |
 Analog Devices |
|
DataSheet.es es una pagina web que funciona como un repositorio de manuales o hoja de datos de muchos de los productos más populares, |
| DataSheet.es | 2020 | Privacy Policy | Contacto | Buscar |