|
|
PDF LT1359CS Data sheet ( Hoja de datos )
| Número de pieza | LT1359CS | |
| Descripción | Dual and Quad 25MHz/ 600V/us Op Amps | |
| Fabricantes | Linear Technology | |
| Logotipo |  |
|
Hay una vista previa y un enlace de descarga de LT1359CS (archivo pdf) en la parte inferior de esta página. Total 12 Páginas | ||
|
No Preview Available !
FEATURES
s 25MHz Gain Bandwidth
s 600V/µs Slew Rate
s 2.5mA Maximum Supply Current per Amplifier
s Unity-Gain Stable
s C-LoadTM Op Amp Drives All Capacitive Loads
s 8nV/√Hz Input Noise Voltage
s 600µV Maximum Input Offset Voltage
s 500nA Maximum Input Bias Current
s 120nA Maximum Input Offset Current
s 20V/mV Minimum DC Gain, RL=1k
s 115ns Settling Time to 0.1%, 10V Step
s 220ns Settling Time to 0.01%, 10V Step
s ±12.5V Minimum Output Swing into 500Ω
s ±3V Minimum Output Swing into 150Ω
s Specified at ±2.5V, ±5V, and ±15V
U
APPLICATIO S
s Wideband Amplifiers
s Buffers
s Active Filters
s Data Acquisition Systems
s Photodiode Amplifiers
TYPICAL APPLICATIO
DAC I-to-V Converter
LT1358/LT1359
Dual and Quad
25MHz, 600V/µs Op Amps
DESCRIPTIO
The LT1358/LT1359 are dual and quad low power high
speed operational amplifiers with outstanding AC and DC
performance. The amplifiers feature much lower supply
current and higher slew rate than devices with comparable
bandwidth. The circuit topology is a voltage feedback
amplifier with matched high impedance inputs and the
slewing performance of a current feedback amplifier. The
high slew rate and single stage design provide excellent
settling characteristics which make the circuit an ideal
choice for data acquisition systems. Each output drives a
500Ω load to ±12.5V with ±15V supplies and a 150Ω load
to ±3V on ±5V supplies. The amplifiers are stable with any
capacitive load making them useful in buffer applications.
The LT1358/LT1359 are members of a family of fast, high
performance amplifiers using this unique topology and
employing Linear Technology Corporation’s advanced
bipolar complementary processing. For a single amplifier
version of the LT1358/LT1359 see the LT1357 data sheet.
For higher bandwidth devices with higher supply currents
see the LT1360 through LT1365 data sheets. For lower
supply current amplifiers see the LT1354 and LT1355/
LT1356 data sheets. Singles, duals, and quads of each
amplifier are available.
, LTC and LT are registered trademarks of Linear Technology Corporation.
C-Load is a trademark of Linear Technology Corporation
AV = –1 Large-Signal Response
DAC 12
INPUTS
5k
565A-TYPE
6pF
–
1/2
LT1358
+
VOUT
0.1µF
( )5k
VOS+ IOS
5kΩ
+
V OUT
A VOL
< 1LSB
1358/1359 TA01
1358/1359 TA02
1
1 page  
LT1358/LT1359
ELECTRICAL CHARACTERISTICS The q denotes the specifications which apply over the temperature range
– 40°C ≤ TA ≤ 85°C, VCM = 0V unless otherwise noted. (Note 8)
SYMBOL PARAMETER
AVOL Large-Signal Voltage Gain
VOUT
Output Swing
IOUT Output Current
ISC Short-Circuit Current
SR Slew Rate
CONDITIONS
VOUT = ±12V, RL = 1k
VOUT = ±10V, RL = 500Ω
VOUT = ±2.5V, RL = 1k
VOUT = ±2.5V, RL = 500Ω
VOUT = ±2.5V, RL = 150Ω
VOUT = ±1V, RL = 500Ω
RL = 1k, VIN = ±40mV
RL = 500Ω, VIN = ±40mV
RL = 500Ω, VIN = ±40mV
RL = 150Ω, VIN = ±40mV
RL = 500Ω, VIN = ±40mV
VOUT = ±12V
VOUT = ±2.6V
VOUT = 0V, VIN = ±3V
AV = – 2, (Note 4)
VSUPPLY
±15V
±15V
±5V
±5V
±5V
±2.5V
±15V
±15V
±5V
±5V
±2.5V
±15V
±5V
±15V
±15V
±5V
MIN
q 10.0
q 2.5
q 10.0
q 2.5
q 0.6
q 2.5
q 13.0
q 12.0
q 3.4
q 2.6
q 1.2
q 24.0
q 17.3
q 24
q 180
q 100
TYP MAX
UNITS
V/mV
V/mV
V/mV
V/mV
V/mV
V/mV
±V
±V
±V
±V
±V
mA
mA
mA
V/µs
V/µs
GBW Gain Bandwidth
f = 200kHz, RL = 2k
±15V
±5V
q 14
q 11
MHz
MHz
Channel Separation
IS Supply Current
VOUT = ±10V, RL = 500Ω
Each Amplifier
Each Amplifier
±15V
±15V
±5V
q 98
q
q
3.0
2.9
dB
mA
mA
Note 1: Absolute Maximum Ratings are those values beyond which the life
of a device may be impaired.
Note 2: Differential inputs of ±10V are appropriate for transient operation
only, such as during slewing. Large, sustained differential inputs will cause
excessive power dissipation and may damage the part. See Input
Considerations in the Applications Information section of this data sheet
for more details.
Note 3: A heat sink may be required to keep the junction temperature
below absolute maximum when the output is shorted indefinitely.
Note 4: Slew rate is measured between ±10V on the output with ±6V input
for ±15V supplies and ±1V on the output with ±1.75V input for ±5V
supplies.
Note 5: Full power bandwidth is calculated from the slew rate
measurement: FPBW = (SR)/2πVP.
Note 6: This parameter is not 100% tested.
Note 7. The LT1358C/LT1359C are guaranteed functional over the
operating temperature range of –40°C to 85°C.
Note 8: The LT1358C/LT1359C are guaranteed to meet specified
performance from 0°C to 70°C. The LT1358C/LT1359C are designed,
characterized and expected to meet specified performance from – 40°C to
85°C, but are not tested or QA sampled at these temperatures. For
guaranteed I-grade parts, consult the factory.
TYPICAL PERFORMANCE CHARACTERISTICS
Supply Current vs Supply Voltage
and Temperature
3.0
2.5
125°C
2.0 25°C
Input Common Mode Range vs
Supply Voltage
V+
– 0.5
TA = 25°C
∆VOS < 1mV
–1.0
–1.5
–2.0
1.5
1.0
0.5
0
– 55°C
5 10 15 20
SUPPLY VOLTAGE (±V)
1358/1359 G01
2.0
1.5
1.0
0.5
V–
0
5 10 15 20
SUPPLY VOLTAGE (±V)
1358/1359 G02
Input Bias Current vs
Input Common Mode Voltage
400
VS = ±15V
300
TA =
IB =
25°C
—IB+—+—IB—–
2
200
100
0
–100
–200
–15
–10 –5 0
5 10 15
INPUT COMMON MODE VOLTAGE (V)
1358/1359 G03
5
5 Page 
WW
SI PLIFIED SCHE ATIC
V+
R1
500Ω
–IN
V–
LT1358/LT1359
+IN
C
RC
OUT
CC
1358/1359 SS01
PACKAGE DESCRIPTION Dimension in inches (millimeters) unless otherwise noted.
0.300 – 0.325
(7.620 – 8.255)
N8 Package
8-Lead PDIP (Narrow 0.300)
(LTC DWG # 05-08-1510)
0.045 – 0.065
(1.143 – 1.651)
0.130 ± 0.005
(3.302 ± 0.127)
0.400*
(10.160)
MAX
87 65
0.009 – 0.015
(0.229 – 0.381)
0.065
(1.651)
TYP
+0.035
0.325 –0.015
( )8.255
+0.889
–0.381
0.100
(2.54)
BSC
*THESE DIMENSIONS DO NOT INCLUDE MOLD FLASH OR PROTRUSIONS.
MOLD FLASH OR PROTRUSIONS SHALL NOT EXCEED 0.010 INCH (0.254mm)
0.125
(3.175)
MIN
0.018 ± 0.003
(0.457 ± 0.076)
0.020
(0.508)
MIN
0.255 ± 0.015*
(6.477 ± 0.381)
12
34
N8 1098
N Package
14-Lead PDIP (Narrow 0.300)
(LTC DWG # 05-08-1510)
0.300 – 0.325
(7.620 – 8.255)
0.130 ± 0.005
(3.302 ± 0.127)
0.045 – 0.065
(1.143 – 1.651)
0.770*
(19.558)
MAX
14 13 12 11 10
9
8
0.009 – 0.015
(0.229 – 0.381)
0.020
(0.508)
MIN
+0.035
0.325 –0.015
( )8.255
+0.889
–0.381
0.125
(3.175)
MIN
0.005
(0.125)
MIN 0.100
(2.54)
*THESE DIMENSIONS DO NOT INCLUDE MOLD FLASH OR PROTRUSIONS.
BSC
MOLD FLASH OR PROTRUSIONS SHALL NOT EXCEED 0.010 INCH (0.254mm)
0.065
(1.651)
TYP
0.255 ± 0.015*
(6.477 ± 0.381)
0.018 ± 0.003
(0.457 ± 0.076)
1 234 56 7
N14 1098
Information furnished by Linear Technology Corporation is believed to be accurate and reliable.
However, no responsibility is assumed for its use. Linear Technology Corporation makes no represen-
tation that the interconnection of its circuits as described herein will not infringe on existing patent rights.
11
11 Page | ||
| Páginas | Total 12 Páginas | |
| PDF Descargar | [ Datasheet LT1359CS.PDF ] | |
Hoja de datos destacado
| Número de pieza | Descripción | Fabricantes |
| LT1359CN | Dual and Quad 25MHz/ 600V/us Op Amps | Linear Technology |
| LT1359CS | Dual and Quad 25MHz/ 600V/us Op Amps | Linear Technology |
| Número de pieza | Descripción | Fabricantes |
| SLA6805M | High Voltage 3 phase Motor Driver IC. |
 Sanken |
| SDC1742 | 12- and 14-Bit Hybrid Synchro / Resolver-to-Digital Converters. |
 Analog Devices |
|
DataSheet.es es una pagina web que funciona como un repositorio de manuales o hoja de datos de muchos de los productos más populares, |
| DataSheet.es | 2020 | Privacy Policy | Contacto | Buscar |