|
|
PDF MC10E016 Data sheet ( Hoja de datos )
| Número de pieza | MC10E016 | |
| Descripción | 8-BIT SYNCHRONOUS BINARY UP COUNTER | |
| Fabricantes | ON Semiconductor | |
| Logotipo |  |
|
Hay una vista previa y un enlace de descarga de MC10E016 (archivo pdf) en la parte inferior de esta página. Total 11 Páginas | ||
|
No Preview Available !
MC10E016, MC100E016
5.0 V ECL 8‐Bit
Synchronous Binary Up
Counter
Description
The MC10E/100E016 is a high-speed synchronous, presettable,
cascadable 8-bit binary counter. Architecture and operation are the
same as the MC10H016 in the MECL 10H™ family, extended to
8-bits, as shown in the logic symbol.
The counter features internal feedback of TC, gated by the TCLD
(terminal count load) pin. When TCLD is LOW (or left open, in which
case it is pulled LOW by the internal pull-downs), the TC feedback is
disabled, and counting proceeds continuously, with TC going LOW to
indicate an all-one state. When TCLD is HIGH, the TC feedback
causes the counter to automatically reload upon TC = LOW, thus
functioning as a programmable counter. The Qn outputs do not need to
be terminated for the count function to operate properly. To minimize
noise and power, unused Q outputs should be left unterminated.
The 100 series contains temperature compensation.
Features
• 700 MHz Min. Count Frequency
• 1000 ps CLK to Q, TC
• Internal TC Feedback (Gated)
• 8-Bit
• Fully Synchronous Counting and TC Generation
• Asynchronous Master Reset
• PECL Mode Operating Range: VCC = 4.2 V to 5.7 V
with VEE = 0 V
• NECL Mode Operating Range: VCC = 0 V
with VEE = −4.2 V to −5.7 V
• These Devices are Pb-Free, Halogen Free and are RoHS Compliant
www.onsemi.com
PLCC−28
FN SUFFIX
CASE 776−02
MARKING DIAGRAM*
1
MCxxxE016G
AWLYYWW
xxx = 10 or 100
A = Assembly Location
WL = Wafer Lot
YY = Year
WW = Work Week
G = Pb-Free Package
*For additional marking information, refer to
Application Note AND8002/D.
ORDERING INFORMATION
Device
MC10E016FNG
MC10E016FNR2G
MC100E016FNG
MC100E016FNR2G
Package
PLCC−28
(Pb-Free)
PLCC−28
(Pb-Free)
PLCC−28
(Pb-Free)
PLCC−28
(Pb-Free)
Shipping
37 Units/Tube
500 Tape & Reel
37 Units/Tube
500 Tape & Reel
†For information on tape and reel specifications, in-
cluding part orientation and tape sizes, please refer
to our Tape and Reel Packaging Specifications
Brochure, BRD8011/D.
© Semiconductor Components Industries, LLC, 2016
July, 2016 − Rev. 8
1
Publication Order Number:
MC10E016/D
1 page  
MC10E016, MC100E016
Table 7. 10E SERIES NECL DC CHARACTERISTICS (VCCx = 0.0 V; VEE = −5.0 V (Note 1))
0°C
25°C
85°C
Symbol
Characteristic
Min Typ Max Min Typ Max Min Typ Max Unit
IEE Power Supply Current
VOH Output HIGH Voltage (Note 2)
VOL Output LOW Voltage (Note 2)
VIH Input HIGH Voltage
VIL Input LOW Voltage
IIH Input HIGH Current
IIL Input LOW Current
151 181
151 181
151 181
−1020 −930 −840 −980 −895 −810 −910 −815 −720
−1950 −1790 −1630 −1950 −1790 −1630 −1950 −1773 −1595
−1170 −1005 −840 −1130 −970 −810 −1060 −890 −720
−1950 −1715 −1480 −1950 −1715 −1480 −1950 −1698 −1445
150 150 150
0.5 0.3
0.5 0.065
0.3 0.2
mA
mV
mV
mV
mV
mA
mA
NOTE: Device will meet the specifications after thermal equilibrium has been established when mounted in a test socket or printed circuit
board with maintained transverse airflow greater than 500 lfpm. Electrical parameters are guaranteed only over the declared
operating temperature range. Functional operation of the device exceeding these conditions is not implied. Device specification
limit values are applied individually under normal operating conditions and not valid simultaneously.
1. Input and output parameters vary 1:1 with VCC. VEE can vary −0.46 V / +0.06 V.
2. Outputs are terminated through a 50 W resistor to VCC − 2.0 V.
Table 8. 100E SERIES PECL DC CHARACTERISTICS (VCCx = 5.0 V; VEE = 0.0 V (Note 1))
0°C 25°C
Symbol
Characteristic
Min Typ Max Min Typ Max
IEE Power Supply Current
151 181
151 181
VOH Output HIGH Voltage (Note 2)
3975 4050 4120 3975 4050 4120
VOL Output LOW Voltage (Note 2)
VIH Input HIGH Voltage
3190
3835
3295
3975
3380
4120
3190
3835
3255
3975
3380
4120
VIL Input LOW Voltage
3190 3355 3525 3190 3355 3525
IIH Input HIGH Current
150 150
IIL Input LOW Current
0.5 0.3
0.5 0.25
Min
3975
3190
3835
3190
0.5
85°C
Typ
174
4050
3260
3975
3355
0.2
Max
208
4120
3380
4120
3525
150
Unit
mA
mV
mV
mV
mV
mA
mA
NOTE: Device will meet the specifications after thermal equilibrium has been established when mounted in a test socket or printed circuit
board with maintained transverse airflow greater than 500 lfpm. Electrical parameters are guaranteed only over the declared
operating temperature range. Functional operation of the device exceeding these conditions is not implied. Device specification
limit values are applied individually under normal operating conditions and not valid simultaneously.
1. Input and output parameters vary 1:1 with VCC. VEE can vary −0.46 V / +0.8 V.
2. Outputs are terminated through a 50 W resistor to VCC − 2.0 V.
www.onsemi.com
5
5 Page 
MC10E016, MC100E016
MECL is a trademark of Motorola, Inc. LLC (SCILLC) or its subsidiaries in the United States and/or other countries.
ON Semiconductor and are trademarks of Semiconductor Components Industries, LLC dba ON Semiconductor or its subsidiaries in the United States and/or other countries.
ON Semiconductor owns the rights to a number of patents, trademarks, copyrights, trade secrets, and other intellectual property. A listing of ON Semiconductor’s product/patent
coverage may be accessed at www.onsemi.com/site/pdf/Patent−Marking.pdf. ON Semiconductor reserves the right to make changes without further notice to any products herein.
ON Semiconductor makes no warranty, representation or guarantee regarding the suitability of its products for any particular purpose, nor does ON Semiconductor assume any liability
arising out of the application or use of any product or circuit, and specifically disclaims any and all liability, including without limitation special, consequential or incidental damages.
Buyer is responsible for its products and applications using ON Semiconductor products, including compliance with all laws, regulations and safety requirements or standards,
regardless of any support or applications information provided by ON Semiconductor. “Typical” parameters which may be provided in ON Semiconductor data sheets and/or
specifications can and do vary in different applications and actual performance may vary over time. All operating parameters, including “Typicals” must be validated for each customer
application by customer’s technical experts. ON Semiconductor does not convey any license under its patent rights nor the rights of others. ON Semiconductor products are not
designed, intended, or authorized for use as a critical component in life support systems or any FDA Class 3 medical devices or medical devices with a same or similar classification
in a foreign jurisdiction or any devices intended for implantation in the human body. Should Buyer purchase or use ON Semiconductor products for any such unintended or unauthorized
application, Buyer shall indemnify and hold ON Semiconductor and its officers, employees, subsidiaries, affiliates, and distributors harmless against all claims, costs, damages, and
expenses, and reasonable attorney fees arising out of, directly or indirectly, any claim of personal injury or death associated with such unintended or unauthorized use, even if such
claim alleges that ON Semiconductor was negligent regarding the design or manufacture of the part. ON Semiconductor is an Equal Opportunity/Affirmative Action Employer. This
literature is subject to all applicable copyright laws and is not for resale in any manner.
PUBLICATION ORDERING INFORMATION
LITERATURE FULFILLMENT:
Literature Distribution Center for ON Semiconductor
19521 E. 32nd Pkwy, Aurora, Colorado 80011 USA
Phone: 303−675−2175 or 800−344−3860 Toll Free USA/Canada
Fax: 303−675−2176 or 800−344−3867 Toll Free USA/Canada
Email: [email protected]
N. American Technical Support: 800−282−9855 Toll Free
USA/Canada
Europe, Middle East and Africa Technical Support:
Phone: 421 33 790 2910
Japan Customer Focus Center
Phone: 81−3−5817−1050
www.onsemi.com
11
ON Semiconductor Website: www.onsemi.com
Order Literature: http://www.onsemi.com/orderlit
For additional information, please contact your local
Sales Representative
MC10E016/D
11 Page | ||
| Páginas | Total 11 Páginas | |
| PDF Descargar | [ Datasheet MC10E016.PDF ] | |
Hoja de datos destacado
| Número de pieza | Descripción | Fabricantes |
| MC10E016 | 8-Bit Synchronous Binary Up Counter |  Motorola Semiconductors |
| MC10E016 | 8-BIT SYNCHRONOUS BINARY UP COUNTER | ON Semiconductor |
| Número de pieza | Descripción | Fabricantes |
| SLA6805M | High Voltage 3 phase Motor Driver IC. |
 Sanken |
| SDC1742 | 12- and 14-Bit Hybrid Synchro / Resolver-to-Digital Converters. |
 Analog Devices |
|
DataSheet.es es una pagina web que funciona como un repositorio de manuales o hoja de datos de muchos de los productos más populares, |
| DataSheet.es | 2020 | Privacy Policy | Contacto | Buscar |