DataSheet.es    


PDF CXP820P60 Data sheet ( Hoja de datos )

Número de pieza CXP820P60
Descripción CMOS 8-bit Single Chip Microcomputer
Fabricantes Sony Corporation 
Logotipo Sony Corporation Logotipo



Hay una vista previa y un enlace de descarga de CXP820P60 (archivo pdf) en la parte inferior de esta página.


Total 23 Páginas

No Preview Available ! CXP820P60 Hoja de datos, Descripción, Manual

CXP820P60
CMOS 8-bit Single Chip Microcomputer
Description
The CXP820P60 is a CMOS 8-bit single chip
microcomputer integrating on a single chip an A/D
converter, serial interface, timer/counter, time-base
timer, capture timer/counter, fluorescent display panel
controller/driver, remote control reception circuit, and
PWM output circuit besides the basic configurations
of 8-bit CPU, ROM, RAM, and I/O port.
The CXP820P60 also provides sleep/stop function
that enables lower power consumption.
CXP820P60 is the PROM-incorporated version of the
CXP82052/82060 with bult-in mask ROM. This provides
the additional feature of being able to write directly into
the program. Thus, it is most suitable for evaluation
use during system development and for small-quantity
production.
100 pin QFP (Plastic)
Structure
Silicon gate CMOS IC
Features
Wide-range instruction system (213 instructions) to cover various types of data
— 16-bit arithmetic/multiplication and division/Boolean bit operation instructions
Minimum instruction cycle
250ns at 16MHz operation
122µs at 32kHz operation
Incorporated PROM capacity
60K bytes
Incorporated RAM capacity
3984 bytes (including fluorescent display area)
Peripheral functions
— A/D converter
8 bits, 8 channels, successive approximation method
(Conversion time of 3.25µs/16MHz)
— Serial interface
Incorporated buffer RAM (Auto transfer for 1 to 32 bytes), 1 channel
8-bit clock synchronized type, (MSB/LSB first selectable), 1 channel
Start-stop synchronization (UART), 1 channel
— Timer
8-bit timer, 8-bit timer/counter, 19-bit time-base timer
16-bit capture timer/counter, 32kHz timer/counter
— Fluorescent display panel
Supports the universal grid fluorescent display panel
controller/driver
High voltage drive output port of 56 pins (40V)
Maximum of 640 segments display possible
Display timing number of 1 to 20
Dimmer function
Incorporated pull-down resistor (mask option)
Hardware key scan function (Maximum of 16 × 8 key matrix
supportable)
— Remote control reception circuit 8-bit pulse measurement counter, 6-stage FIFO
— PWM output
14 bits, 1 channel
Interruption
17 factors, 15 vectors, multi-interruption possible
Standby mode
Sleep/stop
Package
100-pin plastic QFP
Piggy/Evaluation chip
CXP82000 100-pin ceramic QFP
Sony reserves the right to change products and specifications without prior notice. This information does not convey any license by
any implication or otherwise under any patents or other right. Application circuits shown, if any, are typical examples illustrating the
operation of the devices. Sony cannot assume responsibility for any problems arising out of the use of these circuits.
–1–
E97638-PS

1 page




CXP820P60 pdf
CXP820P60
Symbol
PF0/A47
to
PF7/A40
PG0/A39
to
PG7/A32
PH0/A31
to
PH7/A24
PI0
PI1
PI2/TX
PI3/TEX
A16 to A23
G0/A0
to
G15/A15
VFDP
EXTAL
XTAL
RST
Vpp
VDD
VSS
I/O
I/O/Output
Output/Output
Output/Output
Input
Input
Input
Input/Input
Output
Output/Output
Input
Input
Functions
(Port F)
8-bit output port. I/O can be set
in a unit of single bits.
(8 pins)
FDP segment signal (anode
connection) outputs.
(8 pins)
(Port G)
8-bit output port.
(8 pins)
FDP segment signal (anode
connection) outputs.
(8 pins)
(Port H)
8-bit output port.
(8 pins)
FDP segment signal (anode
connection) outputs.
(8 pins)
(Port I)
4-bit input port.
(4 pins)
Crystal connectors for 32kHz timer/counter clock
oscillation. For usage as event counter, input to TEX,
and leave TX open.
FDP segment signal (anode connection) outputs.
(8 pins)
Outputs for FDP timing signals (grid connection)/segment signals (anode
connection).
(16 pins)
FDP voltage supply for incorporated pull-down (PD) resistor.
Crystal connectors for system clock oscillation. When the clock is
supplied externally, input to EXTAL; opposite phase clock should be
input to XTAL.
Low-level active, system reset.
Vcc supply for incorporated PROM writing.
Leave this pin open during normal operation.
Positive power supply.
GND.
–5–

5 Page





CXP820P60 arduino
CXP820P60
Absolute Maximum Ratings
(Vss = 0V reference)
Item
Symbol
Rating
Unit
Remarks
Supply voltage
VDD
Vpp
FDP display supply voltage VFDP
Input voltage
VIN
Output voltage
VOUT
Display output voltage
VOD
IOH
–0.3 to +7.0
–0.3 to +13.0
–402 to +7.01
–0.3 to +7.01
–0.3 to +7.01
–402 to +7.01
–5
V
V Incorporated PROM
V
V
V
V
mA
All pins excluding display outputs3
(value per pin)
High level output current IODH1 –15 mA Display outputs A20 to A55 (value per pin)
IODH2
–50
mA
Display outputs G0/A0 to G15/A15, and
A16 to A19 (value per pin)
High level total output
current
IOH
IODH
–30
–120
mA Total for all pins excluding display outputs
mA Total for all display outputs
Low level output current
IOL
IOLC
15
mA
Pins excluding large current output
(value per pin)
20 mA Large current output pins4 (value per pin)
Low level total output current IOL
100 mA Total for all output pins
Operating temperature
Topr
–20 to +75
°C
Storage temperature
Tstg –55 to +150 °C
Allowable power dissipation PD
600 mW
1 VIN, VOUT and VOD must not exceed VDD + 0.3V.
2 VFDP and VOD must not exceed VDD – 40V.
3 Specifies output current of general-purpose I/O ports.
4 The large current drive transistor is the N-CH transistor of Port C (PC).
Note) Usage exceeding absolute maximum ratings may permanently impair the LSI. Normal operation should be
conducted under the recommended operating conditions. Exceeding these conditions may adversely affect
the reliability of the LSI.
– 11 –

11 Page







PáginasTotal 23 Páginas
PDF Descargar[ Datasheet CXP820P60.PDF ]




Hoja de datos destacado

Número de piezaDescripciónFabricantes
CXP820P60CMOS 8-bit Single Chip MicrocomputerSony Corporation
Sony Corporation

Número de piezaDescripciónFabricantes
SLA6805M

High Voltage 3 phase Motor Driver IC.

Sanken
Sanken
SDC1742

12- and 14-Bit Hybrid Synchro / Resolver-to-Digital Converters.

Analog Devices
Analog Devices


DataSheet.es es una pagina web que funciona como un repositorio de manuales o hoja de datos de muchos de los productos más populares,
permitiéndote verlos en linea o descargarlos en PDF.


DataSheet.es    |   2020   |  Privacy Policy  |  Contacto  |  Buscar