|
|
PDF PIC16CR72 Data sheet ( Hoja de datos )
| Número de pieza | PIC16CR72 | |
| Descripción | 8-Bit CMOS Microcontrollers | |
| Fabricantes | Microchip | |
| Logotipo |  |
|
Hay una vista previa y un enlace de descarga de PIC16CR72 (archivo pdf) en la parte inferior de esta página. Total 30 Páginas | ||
|
No Preview Available !
PIC16C72 SERIES
8-Bit CMOS Microcontrollers with A/D Converter
Devices included:
• PIC16C72
• PIC16CR72
Microcontroller Core Features:
• High-performance RISC CPU
• Only 35 single word instructions to learn
• All single cycle instructions except for program
branches which are two cycle
• Operating speed: DC - 20 MHz clock input
DC - 200 ns instruction cycle
• 2K x 14 words of Program Memory,
128 x 8 bytes of Data Memory (RAM)
• Interrupt capability
• Eight level deep hardware stack
• Direct, indirect, and relative addressing modes
• Power-on Reset (POR)
• Power-up Timer (PWRT) and
Oscillator Start-up Timer (OST)
• Watchdog Timer (WDT) with its own on-chip RC
oscillator for reliable operation
• Programmable code-protection
• Power saving SLEEP mode
• Selectable oscillator options
• Low-power, high-speed CMOS technology
• Fully static design
• Wide operating voltage range:
- 2.5V to 6.0V (PIC16C72)
- 2.5V to 5.5V (PIC16CR72)
• High Sink/Source Current 25/25 mA
• Commercial, Industrial and Extended temperature
ranges
• Low-power consumption:
- < 2 mA @ 5V, 4 MHz
- 15 A typical @ 3V, 32 kHz
- < 1 A typical standby current
Pin Diagrams
SDIP, SOIC, SSOP,
Windowed Side Brazed Ceramic
MCLR/VPP
RA0/AN0
RA1/AN1
RA2/AN2
RA3/AN3/VREF
RA4/T0CKI
RA5/SS/AN4
VSS
OSC1/CLKIN
OSC2/CLKOUT
RC0/T1OSO/T1CKI
RC1/T1OSI
RC2/CCP1
RC3/SCK/SCL
• 1 28
2 27
3 26
4 25
5 24
6 23
7 22
8 21
9 20
10 19
11 18
12 17
13 16
14 15
PIC16C72
PIC16CR72
RB7
RB6
RB5
RB4
RB3
RB2
RB1
RB0/INT
VDD
VSS
RC7
RC6
RC5/SDO
RC4/SDI/SDA
Peripheral Features:
• Timer0: 8-bit timer/counter with 8-bit prescaler
• Timer1: 16-bit timer/counter with prescaler,
can be incremented during sleep via external
crystal/clock
• Timer2: 8-bit timer/counter with 8-bit period
register, prescaler and postscaler
• Capture, Compare, PWM (CCP) module
- Capture is 16-bit, max. resolution is 12.5 ns
- Compare is 16-bit, max. resolution is 200 ns
- PWM max. resolution is 10-bit
• 8-bit 5-channel analog-to-digital converter
• Synchronous Serial Port (SSP) with
SPI and I2C
• Brown-out detection circuitry for
Brown-out Reset (BOR)
1998-2013 Microchip Technology Inc.
Preliminary
DS39016B-page 1
1 page  
2.0 MEMORY ORGANIZATION
There are two memory blocks in PIC16C72 Series
devices. These are the program memory and the data
memory. Each block has its own bus, so that access to
both blocks can occur during the same oscillator cycle.
The data memory can further be broken down into the
general purpose RAM and the Special Function
Registers (SFRs). The operation of the SFRs that
control the “core” are described here. The SFRs used
to control the peripheral modules are described in the
section discussing each individual peripheral module.
Additional information on device memory may be found
in the PIC® Mid-Range Reference Manual, DS33023.
2.1 Program Memory Organization
PIC16C72 Series devices have a 13-bit program coun-
ter capable of addressing a 2K x 14 program memory
space. The address range for this program memory is
0000h - 07FFh. Accessing a location above the physi-
cally implemented address will cause a wraparound.
The reset vector is at 0000h and the interrupt vector is
at 0004h.
PIC16C72 Series
FIGURE 2-1: PROGRAM MEMORY MAP
AND STACK
PC<12:0>
CALL, RETURN
RETFIE, RETLW
13
Stack Level 1
Stack Level 8
Reset Vector
0000h
Interrupt Vector
On-chip Program
Memory
0004h
0005h
07FFh
0800h
1FFFh
1998-2013 Microchip Technology Inc.
Preliminary
DS39016B-page 5
5 Page 
PIC16C72 Series
2.2.2.3 INTCON REGISTER
The INTCON Register is a readable and writable regis-
ter which contains various enable and flag bits for the
TMR0 register overflow, RB Port change and External
RB0/INT pin interrupts.
Note:
Interrupt flag bits get set when an interrupt
condition occurs regardless of the state of
its corresponding enable bit or the global
enable bit, GIE (INTCON<7>). User soft-
ware should ensure the appropriate inter-
rupt flag bits are clear prior to enabling an
interrupt.
FIGURE 2-5: INTCON REGISTER (ADDRESS 0Bh, 8Bh)
R/W-0
GIE
bit7
R/W-0
PEIE
R/W-0
T0IE
R/W-0
INTE
R/W-0
RBIE
bit 7:
GIE: Global Interrupt Enable bit
1 = Enables all un-masked interrupts
0 = Disables all interrupts
R/W-0
T0IF
R/W-0
INTF
R/W-x
RBIF
bit0
R = Readable bit
W = Writable bit
U = Unimplemented bit,
read as ‘0’
- n = Value at POR reset
bit 6:
PEIE: Peripheral Interrupt Enable bit
1 = Enables all un-masked peripheral interrupts
0 = Disables all peripheral interrupts
bit 5:
T0IE: TMR0 Overflow Interrupt Enable bit
1 = Enables the TMR0 interrupt
0 = Disables the TMR0 interrupt
bit 4:
INTE: RB0/INT External Interrupt Enable bit
1 = Enables the RB0/INT external interrupt
0 = Disables the RB0/INT external interrupt
bit 3:
RBIE: RB Port Change Interrupt Enable bit
1 = Enables the RB port change interrupt
0 = Disables the RB port change interrupt
bit 2:
T0IF: TMR0 Overflow Interrupt Flag bit
1 = TMR0 register has overflowed (must be cleared in software)
0 = TMR0 register did not overflow
bit 1:
INTF: RB0/INT External Interrupt Flag bit
1 = The RB0/INT external interrupt occurred (must be cleared in software)
0 = The RB0/INT external interrupt did not occur
bit 0:
RBIF: RB Port Change Interrupt Flag bit
1 = At least one of the RB7:RB4 pins changed state (must be cleared in software)
0 = None of the RB7:RB4 pins have changed state
1998-2013 Microchip Technology Inc.
Preliminary
DS39016B-page 11
11 Page | ||
| Páginas | Total 30 Páginas | |
| PDF Descargar | [ Datasheet PIC16CR72.PDF ] | |
Hoja de datos destacado
| Número de pieza | Descripción | Fabricantes |
| PIC16CR72 | 8-Bit CMOS Microcontrollers | Microchip |
| PIC16CR73 | 8-Bit CMOS ROM Microcontrollers |  Microchip Technology |
| PIC16CR74 | 8-Bit CMOS ROM Microcontrollers | Microchip Technology |
| PIC16CR76 | 8-Bit CMOS ROM Microcontrollers | Microchip Technology |
| Número de pieza | Descripción | Fabricantes |
| SLA6805M | High Voltage 3 phase Motor Driver IC. |
 Sanken |
| SDC1742 | 12- and 14-Bit Hybrid Synchro / Resolver-to-Digital Converters. |
 Analog Devices |
|
DataSheet.es es una pagina web que funciona como un repositorio de manuales o hoja de datos de muchos de los productos más populares, |
| DataSheet.es | 2020 | Privacy Policy | Contacto | Buscar |