|
|
Número de pieza | INR18650-15L1 | |
Descripción | Lithium-ion Rechargeable Cell | |
Fabricantes | Samsung | |
Logotipo | ||
Hay una vista previa y un enlace de descarga de INR18650-15L1 (archivo pdf) en la parte inferior de esta página. Total 19 Páginas | ||
No Preview Available ! Model
-SAMSUNG SDI Confidential Proprietary –
INR18650-15L Version No.
3.22
SPECIFICATION OF PRODUCT
for Lithium-ion Rechargeable Cell
Model : INR18650-15L1
NMC version
Jul., 2010
Samsung SDI Co., Ltd.
Energy Business Division
1 page -SAMSUNG SDI Confidential Proprietary –
Model INR18650-15L Version No. 3.22
Sang-Uck Kim
10A and 2.5V cut-off after the standard charge is as follows.
Charge temperature
Discharge temperature
0℃ 5℃ 25℃ 45℃ 50℃
Relative capacity 80% 90% 100% 95% 95%
25℃
Note: If charge temperature and discharge temperature is not the same,
the interval for temperature change is 3 hours.
Percentage as an index of the capacity at 25℃(=1,450mAh) is 100%.
7.7 Charge rate capabilities
Discharge capacity is measured with constant current 10A and 2.5V cut-off at 25℃
after the cell is charged with 4.2V as follows.
Charge Condition
Current
0.75A
Rapid 4A
Cut-off
100mA
100mA
Relative
Capacity
100%
98%
Note: Percentage as an index of the discharge capacity at 25℃ and 0.75A charging
(=1450mAh) is 100%.
7.8 Discharge rate capabilities
Discharge capacity is measured with the various currents in under table and 2.5V
cut-off after the standard charge.
Discharge condition
Current
0.3A
4A
10A 15A 18A
Relative
Capacity
104%
97%
100%
97%
95%
Note: Percentage as an index of the capacity at 25℃(=1,450mAh) is 100%.
7.9 Cycle life
Each cycle is an interval between the charge (charge current 0.75A) with 100mA cut-off
and the discharge (discharge current 18A) with 2.5V cut-off.
Capacity after 250cycles,
Capacity ≥ 870mAh (60% of the standard capacity at 25℃)
7.10 Storage characteristics
Capacity after storage for 1 month at 60℃ from the standard charge,
measured with discharge current 10A with 2.5V cut-off at 25℃.
Capacity retention(after the storage) ≥ 1,015mAh (70% of the capacity at 25℃)
7.11 Status of the cell as of ex-factory
The cell should be shipped in 50% charged state. In this case, OCV is from 3.730V to
3.790V.
8. Mechanical Characteristics
8.1 Drop test
- 4/17 -
5 Page -SAMSUNG SDI Confidential Proprietary –
Model INR18650-15L Version No. 3.22
Sang-Uck Kim
6.6.2 Cell Voltage monitoring system.
The system (Charger or Pack) should equip with a device to monitor each
voltage of cell block and to stop charging if the cell imbalance happened.
6.6.4 The battery pack or system should have warning system such as over
temperature, over voltage, over current, and so on.
7. Battery pack assembly
7.1 Prohibition of usage of damaged cell
7.1.1 The cell should be inspected visually before battery assembly.
7.1.2 The cell should not be used if sleeve-damage, can-distorsion and/or
electrolyte-smell is detected.
7.2 Terminals handling
7.2.1 Excessive force on the negative terminal should be avoided when
external lead is welled.
7.3 Transportation
7.3.1 If the cell is necessary to transported to other place, such as the
battery manufacturer, careful precautions should be taken to avoid
damage of cell.
8. Others
8.1 Disassembly
8.1.1 The cell should not be dismantled from the battery pack.
8.1.2 Internal short-circuit caused by disassembly may lead to heat generation
and/or venting.
8.1.3 When the electrolyte is coming in contact with the skin or eyes,
flush immediately with fresh water and seek medical advice.
8.2 Short-circuiting
8.2.1 Short-circuit results in very high current which leads to heat generation.
8.2.3 An appropriate circuitry should be employed to protect accidental
short-circuiting.
8.3 Incineration
8.3.1 Incinerating and disposing of the cell in fire are strictly prohibited,
because it may cause rupture and explosion.
8.4 Immersion
8.4.1 Soaking the cell in water is strictly prohibited, because it may cause
corrosion and leakage of components to be damaged to functions
8.5 Mixing use
8.5.1 Different types of cell, or same types but different cell manufacturer's shall not be
used, which may lead to cell imbalance, cell rupture or damage to system due to
the different characteristics of cell.
8.6 Battery exchange
8.6.1 Although the cell contains no environmentally hazardous component,
such as lead or cadmium, the battery shall be disposed according to
the local regulations when it is disposed.
8.6.2 The cell should be disposed with a discharged state to avoid heat generation
by an inadvertent short-circuit.
8.7 Caution
The Battery used in this device may present a risk of fire or chemical burn if
mistreated.
Do not disassemble, expose to heat above 100℃ or incinerate it.
- 10/17 -
11 Page |
Páginas | Total 19 Páginas | |
PDF Descargar | [ Datasheet INR18650-15L1.PDF ] |
Número de pieza | Descripción | Fabricantes |
INR18650-15L1 | Lithium-ion Rechargeable Cell | Samsung |
Número de pieza | Descripción | Fabricantes |
SLA6805M | High Voltage 3 phase Motor Driver IC. |
Sanken |
SDC1742 | 12- and 14-Bit Hybrid Synchro / Resolver-to-Digital Converters. |
Analog Devices |
DataSheet.es es una pagina web que funciona como un repositorio de manuales o hoja de datos de muchos de los productos más populares, |
DataSheet.es | 2020 | Privacy Policy | Contacto | Buscar |