Datasheet SN74LS247 Equivalent ( PDF ) - Data

SN74LS247 BCD-to-Seven-Segment Decoders, Drivers The SN74LS247 is a BCD-to-Seven-Segment Decoder, Drivers. The LS247 composes the and with the tails. The LS247 has active-low outputs for direct drive of indicators. The LS247 features a lamp test input and have full ripple-blanking input, output controls. An automatic leading and, or trailing-edge zero-blanking control (RBI and RBO) is incorporated

BCD-TO-SEVEN-SEGMENT DECODERS, DRIVERS The SN54, 74LS247 thru SN54, 74LS249 are BCD-to-Seven-Segment Decoder, Drivers. The LS247 and LS248 are functionally and electrically identical to the LS47 and LS48 with the same pinout configuration. The LS249 is a 16-pin version of the 14-pin LS49 and includes full functional capability for lamp test and ripple blanking which was not available in the LS49.

1. N channel 2. Enhancement mode 3. Logic Level

1. N channel Enhancement mode 2. Logic Level

1. N-Channel Enhancement mode Logic Level dv, dt rated 2. VDS 60 V RDS(on) 5 Ω ID 0.2 A

1. N-Channel Enhancement mode Logic Level dv, dt rated 2. VDS 60 V RDS(on) 5 Ω ID 0.23 A

The SN7101 is integrated a high stability band gap voltage reference, two ORed operational amplifiers and a current source. This IC compares the DC voltage and the current level at the output of a switching power supply to an internal reference.

It provides a feedback through an Opto-coupler to the PWM controller IC in the primary side. The controlled current generator can be used to modify the level of current limitation by offsetting the information coming from the current sensing resistor.

The SN7103 is a monolithic IC that includes one independent op-amp and another op-amp for which the non inverting input is wired to a 2.5V fixed Voltage Reference.