DataSheet.es    


PDF MT9D115 Data sheet ( Hoja de datos )

Número de pieza MT9D115
Descripción 1/5-Inch System-On-A-Chip (SOC) CMOS Digital Image Sensor
Fabricantes ON Semiconductor 
Logotipo ON Semiconductor Logotipo



Hay una vista previa y un enlace de descarga de MT9D115 (archivo pdf) en la parte inferior de esta página.


Total 30 Páginas

No Preview Available ! MT9D115 Hoja de datos, Descripción, Manual

MT9D115: 1/5-Inch SOC Digital Image Sensor
Features
1/5-Inch System-On-A-Chip (SOC) CMOS Digital
Image Sensor
MT9D115 Datasheet, Rev. E
For the latest datasheet, please visit www.onsemi.com
Features
• 2 Mp resolution (1600H x 1200V)
• 1/5-inch optical format
• Same or better image quality compared to MT9D112
• Individual module ID support through one-time
programmable (OTP) memory
• Surface fit lens correction (LC) to compensate for
lens/small pixel vignetting and corner color variations
• Automatic functions: Exposure, white balance, black
level offset correction, flicker detection and
avoidance, color saturation control, defect
identification and correction, aperture correction,
and GPIO
• Programmable controls: Exposure, white balance,
horizontal and vertical blanking, color, sharpness,
gamma, lens shading correction, horizontal and
vertical image flip, zoom, windowing, sampling rates,
and GPIO
• 15 frames per second (fps) at 1600H x 1200V with
moderate pixel clock frequency (64 MHz) to
minimize baseband reception interference and 30 fps
at 800H x 600V
• 2 x 2 pixel binning to improve low-light image quality
• Support for external LED or xenon flash
• On-chip phase-locked loop (PLL) to minimize the
number of system clocks
• Low power modes to prolong battery life of portable
devices
• Fail-safe I/Os with programmable output slew rate
• Industry standard two-wire serial interface for
controls
• 10-bit parallel or MIPI serial interfaces for image data
Applications
• Cellular phones
• PC cameras
• PDAs
Table 1:
Key Performance Parameters
Parameter
Pixel size
Optical format
Array format (active)
Imaging area
CRA
Color filter array
Scan mode
Shutter
Input clock range
Output pixel clock
maximum
Output MIPI data rate
maximum
Max. Frame Rate
Responsivity
Signal-to-noise ratio
Dynamic range
Digital
Analog
Supply voltage I/O
MIPI
Power consumption
Operating temperature
range
Package
Value
1.75 m x 1.75 m
1/5-inch
1600H x 1200V = 1.92 Mp
2.8 mm x 2.10 mm: 3.50 mm
diagonal (4:3 aspect ratio)
25°
RGB Bayer
Progressive
Electronic rolling shutter (ERS)
6 – 54 MHz
85 MHz
512 Mb/s
15 fps full res
30 fps 800 x 600
0.65 V/Lux-sec (550 nm)
39 dB (MAX)
63.9 dB (pixel)
1.8 V (nominal)
2.8 V (nominal)
1.8 V or 2.8 V (nominal)
1.7-1.95V
196mW1
–30°C to 70°C (at junction)
Bare die, CSP
Notes: 1. Power consumption for typical voltages at
800 x 600 video mode
MT9D115 DS Rev. E Pub. 4/15 EN
1 ©Semiconductor Components Industries, LLC,2015

1 page




MT9D115 pdf
MT9D115: 1/5-Inch SOC Digital Image Sensor
List of Tables
List of Tables
Table 1:
Table 2:
Table 3:
Table 4:
Table 5:
Table 6:
Table 7:
Table 8:
Table 9:
Table 10:
Table 11:
Table 12:
Table 13:
Table 14:
Table 15:
Table 16:
Table 17:
Table 18:
Table 19:
Table 20:
Table 21:
Table 22:
Table 23:
Table 24:
Table 25:
Table 26:
Table 27:
Table 28:
Table 29:
Table 30:
Key Performance Parameters. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .1
Available Part Numbers. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .2
Signal Description and Direction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .9
List of Drivers. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .11
Two-Wire Serial Interface Timing Data . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .14
Row Address Sequencing (Sampling). . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .23
Row Address Sequencing (Binning) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .24
Data Formats Supported by MIPI Interface . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .32
YCbCr Output Data Ordering. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .33
RGB Ordering in Default Mode . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .33
2-Byte RGB Format. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .34
Power Application Sequence Timing . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .42
POR Parameters . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .43
Hard Reset . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .44
Soft Reset Signal Timing . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .45
Power Down Signal Timing . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .46
Hard Standby Signal Timing . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .48
Soft Standby Signal Timing. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .49
Status of Signals During Different States. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .50
GPIO Related Registers and Variables . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .53
Maximum Rating . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .54
I/O Parameters . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .54
MIPI High-Speed Transmitter DC Characteristics . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .55
MIPI High-Speed Transmitter AC Characteristics. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .55
MIPI Low-Power Transmitter DC Characteristics . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .55
MIPI Low-Power Transmitter AC Characteristics . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .55
AC Electricals . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .56
DC Electricals. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .57
Status of Signals During Standby State . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .60
Typical Mismatch Current in VDD_IO Due to Mismatch in RESET_BAR level and VDD_IO Level . .61
MT9D115 DS Rev. E Pub. 4/15 EN
5 ©Semiconductor Components Industries, LLC,2015.

5 Page





MT9D115 arduino
MT9D115: 1/5-Inch SOC Digital Image Sensor
Architecture
The external host and the integrated microprocessor (MCU) can both access all the
internal resources (RAM and registers). The external host always has higher priority. The
following sections briefly describe the functionality of each key component of the
system.
Firmware
Table 4:
The firmware implements all automatic camera functions, such as auto exposure (AE),
auto white balance (AWB), and flicker detection/avoidance (FD), as well as control func-
tions such as sequencer, mode/context, and histogram (see Table 4). The firmware
consists of drivers, generally one driver for each major automatic or control function
(see Figure 4).
List of Drivers
ID
ID = 1
ID = 2
ID = 3
ID = 4
ID = 7
ID = 11
Driver Name
Sequencer
AE
AWB
Flicker Detection
Mode/Context
Histogram
Description
Controls of camera main function
Auto exposure
Auto white balance
Flicker detection and avoidance
Context variables
Reduce image flare and analyze image histogram
Figure 4:
Firmware Architecture
Operation
Driver
Monitor
Sequencer
Mode
Control
Auto Function
Driver
Auto
White
Balance
Flicker
Avoidance
Auto
Exposure
Hardware
RAM
STAT
IFP
Core
Output
MT9D115 DS Rev. E Pub. 4/15 EN
11
©Semiconductor Components Industries, LLC,2015.

11 Page







PáginasTotal 30 Páginas
PDF Descargar[ Datasheet MT9D115.PDF ]




Hoja de datos destacado

Número de piezaDescripciónFabricantes
MT9D1111/3.2-Inch System-On-A-Chip (SOC) CMOS Digital Image SensorMicron Technology
Micron Technology
MT9D1122M Camera ModuleETC
ETC
MT9D1121/4-Inch 2Mp System-On-A-Chip (SOC) CMOS Digital Image SensorAptina Imaging Corporation
Aptina Imaging Corporation
MT9D1131/5-Inch System-On-A-Chip (SOC) CMOS Digital Image SensorAptina Imaging Corporation
Aptina Imaging Corporation

Número de piezaDescripciónFabricantes
SLA6805M

High Voltage 3 phase Motor Driver IC.

Sanken
Sanken
SDC1742

12- and 14-Bit Hybrid Synchro / Resolver-to-Digital Converters.

Analog Devices
Analog Devices


DataSheet.es es una pagina web que funciona como un repositorio de manuales o hoja de datos de muchos de los productos más populares,
permitiéndote verlos en linea o descargarlos en PDF.


DataSheet.es    |   2020   |  Privacy Policy  |  Contacto  |  Buscar