|
|
PDF MB95FV100D-103 Data sheet ( Hoja de datos )
| Número de pieza | MB95FV100D-103 | |
| Descripción | 8-bit Microcontrollers | |
| Fabricantes | Fujitsu Media Devices | |
| Logotipo |  |
|
Hay una vista previa y un enlace de descarga de MB95FV100D-103 (archivo pdf) en la parte inferior de esta página. Total 30 Páginas | ||
|
No Preview Available !
FUJITSU MICROELECTRONICS
DATA SHEET
DS07-12611-4Ea
8-bit Microcontrollers
CMOS
F2MC-8FX MB95110M series
MB95117M/F114MS/F114NS/F114JS/F116MS/F116NS/F116JS/
www.DataSheetM4U.Bco9m 5F118MS/F118NS/F118JS/F114MW/F114NW/F114JW/
MB95F116MW/F116NW/F116JW/F118MW/F118NW/F118JW/FV100D-103
■ DESCRIPTION
The MB95110M series is general-purpose, single-chip microcontrollers. In addition to a compact instruction set,
the microcontrollers contain a variety of peripheral functions.
Note : F2MC is the abbreviation of FUJITSU Flexible Microcontroller.
■ FEATURES
• F2MC-8FX CPU core
Instruction set optimized for controllers
• Multiplication and division instructions
• 16-bit arithmetic operations
• Bit test branch instruction
• Bit manipulation instructions etc.
• Clock
• Main clock
• Main PLL clock
• Sub clock (for dual clock product)
• Sub PLL clock (for dual clock product)
(Continued)
Be sure to refer to the “Check Sheet” for the latest cautions on development.
“Check Sheet” is seen at the following support page
URL : http://edevice.fujitsu.com/micom/en-support/
“Check Sheet” lists the minimal requirement items to be checked to prevent problems beforehand in system
development.
Copyright©2006-2008 FUJITSU MICROELECTRONICS LIMITED All rights reserved
2007.11
1 page  
MB95110M Series
(Continued)
Part number
Parameter
MB95117M
MB95F114MS/ MB95F114NS/ MB95F114MW/ MB95F114NW/ MB95F114JS/ MB95F114JW/
MB95F116MS/ MB95F116NS/ MB95F116MW/ MB95F116NW/ MB95F116JS/ MB95F116JW/
MB95F118MS MB95F118NS MB95F118MW/ MB95F118NW MB95F118JS MB95F118JW
LIN-UART
(1 channel)
Dedicated reload timer allowing a wide range of communication speeds to be set.
Full duplex double buffer.
Clock asynchronous (UART) or clock synchronous (SIO) serial data transfer
capable.
LIN functions available as the LIN master or LIN slave.
8/10-bit A/D
converter
www.DataSheet4U.co(8mchannels)
8-bit or 10-bit resolution can be selected.
8/16-bit
compound
timer
(2 channels)
Each channel of the timer can be used as “8-bit timer × 2 channels” or
“16-bit timer × 1 channel”.
Built-in timer function, PWC function, PWM function, capture function, and square waveform
output
Count clock : 7 internal clocks and external clock can be selected
16-bit PPG
(1 channel)
8/16-bit PPG
(2 channels)
PWM mode or one-shot mode can be selected.
Counter operating clock : 8 selectable clock sources
Support for external trigger start
Each channel of the PPG can be used as “8-bit PPG × 2 channels” or “16-bit PPG × 1 channel”.
Counter operating clock : Eight selectable clock sources
Watch counter Count clock : 4 selectable clock sources (125 ms, 250 ms, 500 ms, or 1 s)
(for dual clock Counter value can be set from 0 to 63 (Capable of counting for 1minute when
product)
selecting clock source 1 second and setting counter value to 60).
Watch
prescaler
(for dual clock 4 selectable interval times (125 ms, 250 ms, 500 ms, or 1 s)
product)
(1 channel)
External
interrupt
(8 channels)
Interrupt by edge detection (rising, falling, or both edges can be selected.)
Can be used to recover from standby modes.
Flash memory
Supports automatic programming, Embedded Algorithm
Write/Erase/Erase-Suspend/Resume commands
A flag indicating completion of the algorithm
Number of write/erase cycles (Minimum) : 10000 times
Data retention time: 20 years
Erase can be performed on each block
Block protection with external programming voltage
Dual operation Flash memory
Flash Security Feature for protecting the content of the Flash
Standby mode Sleep, stop, watch (for dual clock product) , and time-base timer
*1 : For ROM capacitance and RAM capacitance, refer to “■ MEMORY LINEUP”.
*2 : When the MASK ROM is ordered, please select yes/no for the clock mode, low voltage detection, clock
supervisor and reset output.
*3 : Specify clock mode when ordering MASK ROM.
Note : Part number of the evaluation products in MB95110M series is MB95FV100D-103. When using it, the MCU
board (MB2146-303A) is required.
5
5 Page 
MB95110M Series
■ I/O CIRCUIT TYPE
Type
A
X1 (X1A)
X0 (X0A)
www.DataSheet4U.com Standby control
B
R
Circuit
Clock input
N-ch
Mode input
Remarks
• Oscillation circuit
• High-speed side
Feedback resistance : approx. 1 MΩ
• Low-speed side
Feedback resistance : approx. 24 MΩ
(Evaluation product : approx. 10 MΩ)
Dumping resistance : approx. 144 MΩ)
(Evaluation product : without dumping
resistance)
Only for input
Hysteresis input
With pull-down resistor only for MASK
ROM product
B’
Reset input
Reset output
N-ch
• Reset output
• Hysteresis input
C
Standby control
External interrupt
enable
G
R
P-ch
Standby control
• CMOS output
P-ch
Digital output
• Hysteresis input
• Automotive input
Digital output
N-ch
Hysteresis input
Automotive input
Pull-up control
P-ch Digital output
Digital output
N-ch
• CMOS output
• CMOS input
• Hysteresis input
• With pull-up control
• Automotive input
CMOS input
Hysteresis input
Automotive input
(Continued)
11
11 Page | ||
| Páginas | Total 30 Páginas | |
| PDF Descargar | [ Datasheet MB95FV100D-103.PDF ] | |
Hoja de datos destacado
| Número de pieza | Descripción | Fabricantes |
| MB95FV100D-101 | 8-bit Proprietary Microcontrollers | Fujitsu Media Devices |
| MB95FV100D-101 | 8-bit Proprietary Microcontrollers | Fujitsu Media Devices |
| MB95FV100D-101 | 8-bit Microcontroller |  Fujitsu |
| MB95FV100D-102 | 8-bit Proprietary Microcontrollers | Fujitsu Media Devices |
| Número de pieza | Descripción | Fabricantes |
| SLA6805M | High Voltage 3 phase Motor Driver IC. |
 Sanken |
| SDC1742 | 12- and 14-Bit Hybrid Synchro / Resolver-to-Digital Converters. |
 Analog Devices |
|
DataSheet.es es una pagina web que funciona como un repositorio de manuales o hoja de datos de muchos de los productos más populares, |
| DataSheet.es | 2020 | Privacy Policy | Contacto | Buscar |