|
|
PDF LA6458S Data sheet ( Hoja de datos )
| Número de pieza | LA6458S | |
| Descripción | High-Performance Dual Operational Amplifiers | |
| Fabricantes | Sanyo Semiconductor Corporation | |
| Logotipo |  |
|
Hay una vista previa y un enlace de descarga de LA6458S (archivo pdf) en la parte inferior de esta página. Total 5 Páginas | ||
|
No Preview Available !
Ordering number: EN911D
Monolithic Linear IC
LA6458M, 6458S
High-Performance
Dual Operational Amplifiers
Overview
The LA6458 consists of two independent, internally phase
compensated operational amplifiers. Application areas include
active filters, audio preamplifiers, and various electronic
circuits.
.Features
LA6458M : 8-pin MFP package,
LA6458S : 9-pin SIP package
. Phase compensation circuit built in.
. High gain, low noise.
. Slew rate : l.1V/µs typ.
Package Dimensions
unit : mm
3032B-MFP8
[LA6458M]
Specifications
Maximum Ratings at Ta = 25°C
Parameter Symbol Conditions
Maximum
supply voltage
VCC/VEE
Differential
input voltage
VID
Common-mode
input voltage
VIN
Allowable
power
dissipation
LA6458M
Pd max
LA6458S
Operating
temperature
Topr
Storage
temperature
Tstg
Ratings Unit
±18 V
±30 V
±15 V
300 mW
500 mW
–20 to +75 °C
–40 to +125 °C
unit : mm
3017C-SIP9
SANYO : MFP8
[LA6458S]
SANYO : SIP9
Any and all SANYO products described or contained herein do not have specifications that can handle
applications that require extremely high levels of reliability, such as life-support systems, aircraft’s
control systems, or other applications whose failure can be reasonably expected to result in serious
physical and/or material damage. Consult with your SANYO representative nearest you before using
any SANYO products described or contained herein in such applications.
SANYO assumes no responsibility for equipment failures that result from using products at values that
exceed, even momentarily, rated values (such as maximum ratings, operating condition ranges, or other
parameters) listed in products specifications of any and all SANYO products described or contained
herein.
SANYO Electric Co.,Ltd. Semiconductor Bussiness Headquarters
TOKYO OFFICE Tokyo Bldg., 1-10, 1 Chome, Ueno, Taito-ku, TOKYO, 110-8534 JAPAN
63096HA(II)/1100YT/8237KI/8064KI/O064KI,TS No.911-1/5
1 page  
LA6458M, 6458S
Specifications of any and all SANYO products described or contained herein stipulate the performance,
characteristics, and functions of the described products in the independent state, and are not guarantees
of the performance, characteristics, and functions of the described products as mounted in the customer’s
products or equipment. To verify symptoms and states that cannot be evaluated in an independent device,
the customer should always evaluate and test devices mounted in the customer’s products or equipment.
SANYO Electric Co., Ltd. strives to supply high-quality high-reliability products. However, any and all
semiconductor products fail with some probability. It is possible that these probabilistic failures could
give rise to accidents or events that could endanger human lives, that could give rise to smoke or fire,
or that could cause damage to other property. When designing equipment, adopt safety measures so
that these kinds of accidents or events cannot occur. Such measures include but are not limited to protective
circuits and error prevention circuits for safe design, redundant design, and structural design.
In the event that any or all SANYO products(including technical data,services) described or
contained herein are controlled under any of applicable local export control laws and regulations,
such products must not be exported without obtaining the export license from the authorities
concerned in accordance with the above law.
No part of this publication may be reproduced or transmitted in any form or by any means, electronic or
mechanical, including photocopying and recording, or any information storage or retrieval system,
or otherwise, without the prior written permission of SANYO Electric Co., Ltd.
Any and all information described or contained herein are subject to change without notice due to
product/technology improvement, etc. When designing equipment, refer to the “Delivery Specification”
for the SANYO product that you intend to use.
Information (including circuit diagrams and circuit parameters) herein is for example only ; it is not
guaranteed for volume production. SANYO believes information herein is accurate and reliable, but
no guarantees are made or implied regarding its use or any infringements of intellectual property rights
or other rights of third parties.
This catalog provides information as of June, 1996. Specifications and information herein are subject to
change without notice.
PS No.911-5/5
5 Page | ||
| Páginas | Total 5 Páginas | |
| PDF Descargar | [ Datasheet LA6458S.PDF ] | |
Hoja de datos destacado
| Número de pieza | Descripción | Fabricantes |
| LA6458 | High-Performance Dual Operational Amplifiers |  Sanyo |
| LA6458D | High-Performance Dual Operational Amplifiers | Sanyo Semiconductor Corporation |
| LA6458M | High-Performance Dual Operational Amplifiers | Sanyo |
| LA6458S | High-Performance Dual Operational Amplifiers | Sanyo |
| Número de pieza | Descripción | Fabricantes |
| SLA6805M | High Voltage 3 phase Motor Driver IC. |
 Sanken |
| SDC1742 | 12- and 14-Bit Hybrid Synchro / Resolver-to-Digital Converters. |
 Analog Devices |
|
DataSheet.es es una pagina web que funciona como un repositorio de manuales o hoja de datos de muchos de los productos más populares, |
| DataSheet.es | 2020 | Privacy Policy | Contacto | Buscar |