DataSheet.es    


PDF MC10H605 Data sheet ( Hoja de datos )

Número de pieza MC10H605
Descripción Registered Hex ECL/TTL Translator
Fabricantes Motorola Semiconductors 
Logotipo Motorola Semiconductors Logotipo



Hay una vista previa y un enlace de descarga de MC10H605 (archivo pdf) en la parte inferior de esta página.


Total 5 Páginas

No Preview Available ! MC10H605 Hoja de datos, Descripción, Manual

MOTOROLA
SEMICONDUCTOR TECHNICAL DATA
Registered Hex ECL/TTL
Translator
The MC10/100H605 is a 6–bit, registered, dual supply ECL to TTL
translator. The device features differential ECL inputs for both data and
clock. The TTL outputs feature balanced 24mA sink/source capabilities for
driving transmission lines.
With its differential ECL inputs and TTL outputs the H605 device is ideally
suited for the receive function of a HPPI bus type board–to–board interface
application. The on chip registers simplify the task of synchronizing the data
between the two boards.
A VBB reference voltage is supplied for use with single–ended data or
clock. For single–ended applications the VBB output should be connected to
the “bar” inputs (Dn or CLK) and bypassed to ground via a 0.01µF capacitor.
To minimize the skew of the device differential clocks should be used.
The ECL level Master Reset pin is asynchronous and common to all
flip–flops. A “HIGH” on the Master Reset forces the Q outputs “LOW”.
The device is available in either ECL standard: the 10H device is
compatible with MECL 10Hlogic levels while the 100H device is
compatible with 100K logic levels.
Differential ECL Data and Clock Inputs
24mA Sink, 24mA Source TTL Outputs
Dual Power Supply
Multiple Power and Ground Pins to Minimize Noise
2.0ns Part–to–Part Skew
LOGIC SYMBOL
1 OF 6 BITS
Dn
Dn
DQ
Qn
MC10H605
MC100H605
FN SUFFIX
PLASTIC PACKAGE
CASE 776–02
PIN NAMES
PIN FUNCTION
D0–D5
D0–D5
CLK, CLK
MR
Q0–Q5
VCCE
VCCT
GND
VEE
True ECL Data Inputs
Inverted ECL Data Inputs
Differential ECL Clock Input
ECL Master Reset Input
TTL Outputs
ECL VCC
TTL VCC
TTL Ground
ECL VEE
TRUTH TABLE
Dn MR TCLK/CLK
LL
HL
XH
Z
Z
X
Z = LOW to HIGH Transition
Qn+1
L
H
L
CLK
CLK
MR
VBB
CLK
R
Pinout: 28–Lead PLCC (Top View)
Q3 VCCT Q4 GND Q5 VCCT MR
25 24 23 22 21 20 19
Q2 26
18 D5
Q1 27
17 D5
Q0 28
16 D4
GND
15 D4
CLK 2
CLK 3
14 VCCE
13 D3
VBB 4
12 D3
5 6 7 8 9 10 11
D0 D0 VEE D1 D1 D2 D2
MECL 10H is a trademark of Motorola, Inc.
9/96
© Motorola, Inc. 1996
2–306
REV 3

1 page




MC10H605 pdf
MC10H605 MC100H605
Motorola reserves the right to make changes without further notice to any products herein. Motorola makes no warranty, representation or guarantee regarding
the suitability of its products for any particular purpose, nor does Motorola assume any liability arising out of the application or use of any product or circuit, and
specifically disclaims any and all liability, including without limitation consequential or incidental damages. “Typical” parameters which may be provided in Motorola
data sheets and/or specifications can and do vary in different applications and actual performance may vary over time. All operating parameters, including “Typicals”
must be validated for each customer application by customer’s technical experts. Motorola does not convey any license under its patent rights nor the rights of
others. Motorola products are not designed, intended, or authorized for use as components in systems intended for surgical implant into the body, or other
applications intended to support or sustain life, or for any other application in which the failure of the Motorola product could create a situation where personal injury
or death may occur. Should Buyer purchase or use Motorola products for any such unintended or unauthorized application, Buyer shall indemnify and hold Motorola
and its officers, employees, subsidiaries, affiliates, and distributors harmless against all claims, costs, damages, and expenses, and reasonable attorney fees
arising out of, directly or indirectly, any claim of personal injury or death associated with such unintended or unauthorized use, even if such claim alleges that
Motorola was negligent regarding the design or manufacture of the part. Motorola and are registered trademarks of Motorola, Inc. Motorola, Inc. is an Equal
Opportunity/Affirmative Action Employer.
How to reach us:
USA/EUROPE/Locations Not Listed: Motorola Literature Distribution;
P.O. Box 20912; Phoenix, Arizona 85036. 1–800–441–2447 or 602–303–5454
MFAX: [email protected] – TOUCHTONE 602–244–6609
INTERNET: http://Design–NET.com
JAPAN: Nippon Motorola Ltd.; Tatsumi–SPD–JLDC, 6F Seibu–Butsuryu–Center,
3–14–2 Tatsumi Koto–Ku, Tokyo 135, Japan. 03–81–3521–8315
ASIA/PACIFIC: Motorola Semiconductors H.K. Ltd.; 8B Tai Ping Industrial Park,
51 Ting Kok Road, Tai Po, N.T., Hong Kong. 852–26629298
MOTOROLA
*MC10H605/D*2–310
MC10H605/D
MECL Data
DL122 — Rev 6

5 Page










PáginasTotal 5 Páginas
PDF Descargar[ Datasheet MC10H605.PDF ]




Hoja de datos destacado

Número de piezaDescripciónFabricantes
MC10H6009-Bit TTL/ECL TranslatorON Semiconductor
ON Semiconductor
MC10H6009-Bit TTL to ECL TranslatorMotorola Semiconductors
Motorola Semiconductors
MC10H600FN9-Bit TTL/ECL TranslatorMotorola Semiconductors
Motorola Semiconductors
MC10H6019-Bit ECL/TTL TranslatorMotorola Semiconductors
Motorola Semiconductors

Número de piezaDescripciónFabricantes
SLA6805M

High Voltage 3 phase Motor Driver IC.

Sanken
Sanken
SDC1742

12- and 14-Bit Hybrid Synchro / Resolver-to-Digital Converters.

Analog Devices
Analog Devices


DataSheet.es es una pagina web que funciona como un repositorio de manuales o hoja de datos de muchos de los productos más populares,
permitiéndote verlos en linea o descargarlos en PDF.


DataSheet.es    |   2020   |  Privacy Policy  |  Contacto  |  Buscar